Sanyo Katana Camera Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          5 - 10 minutes

Sections

Screen Protector
3 steps
Front Case
1 step
Camera
3 steps

Flags

BackSanyo Katana
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Screen Protector

With the flat end of a spudger, remove the plastic covers located on the corners of the display near the hinge and above the screen, revealing four screws underneath.

With the flat end of a spudger, remove the plastic covers located on the corners of the display near the hinge and above the screen, revealing four screws underneath.

1024

Step 2

Remove the 4.4mm screw in each corner using the Tri-wing Y0 screwdriver.

Remove the 4.4mm screw in each corner using the Tri-wing Y0 screwdriver.

Step 3

Carefully pry the screen protector off the phone using the flat end of the spudger.
This will require a bit of force as the back of the screen protector is lined with an adhesive material.
Once free from the adhesive, pull the screen protector away from the phone.

Carefully pry the screen protector off the phone using the flat end of the spudger.

This will require a bit of force as the back of the screen protector is lined with an adhesive material.

Once free from the adhesive, pull the screen protector away from the phone.

Step 4

              Front Case

Use the spudger to pry off the front case from the left and right sides of the device.
Once it has popped off, pull the casing apart with fingers.

Use the spudger to pry off the front case from the left and right sides of the device.

Once it has popped off, pull the casing apart with fingers.

Step 5

              Camera

Use a Tri-wing Y0 screwdriver to remove the 4.4mm screw.
Use fingers to remove the strip.

Use a Tri-wing Y0 screwdriver to remove the 4.4mm screw.

Use fingers to remove the strip.

Step 6

Detach the ribbon connections underneath the green connector strip and remove them from the device. This will reveal the camera.

Detach the ribbon connections underneath the green connector strip and remove them from the device. This will reveal the camera.

Step 7

Using a spudger, remove the ribbon connection of the camera from the adhesive that attaches it to the device.
Grab the camera using fingers and remove it from the phone case.

Using a spudger, remove the ribbon connection of the camera from the adhesive that attaches it to the device.

Grab the camera using fingers and remove it from the phone case.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors

                    Preston

Member since: 03/11/2013

216 Reputation

                                      5 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges

Team

                       Clemson, Team 12-1, Benson Spring 2013                        

                                                  Member of Clemson, Team 12-1, Benson Spring 2013 



                    CLEM-BENSON-S13S12G1                     


                                            4 Members                     


                                            20 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team