Sanyo Pm 8200 Motherboard Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

Suggest a time??

Sections

3

• Battery
• 2 steps
• Back Casing
• 3 steps
• Motherboard
• 3 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

• BackSanyo-PM 8200

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

What you need

Step 1

              Power Off Phone               

• Power down the phone by holding down the red “end” button.

Power down the phone by holding down the red “end” button.

1024

Step 2

              Remove Old Battery               

• Push and hold the button on the back toward the direction of the arrow to unlock the battery.
• Lift and remove the battery from the back of the phone.

Push and hold the button on the back toward the direction of the arrow to unlock the battery.

Lift and remove the battery from the back of the phone.

Step 3

              Back Casing               

• Use a push pin or tweezers to remove the neoprene screw-cover located on the upper, left corner of the back casing.

Use a push pin or tweezers to remove the neoprene screw-cover located on the upper, left corner of the back casing.

Step 4

• Unscrew all four, 5mm Tri-Wing screws.

Unscrew all four, 5mm Tri-Wing screws.

Step 5

• Pry the back casing off the device using a spudger. Work your way along the edges to completely separate the back casing from the device.
• This step may require extra force. But too much force could break the back casing.
• Remove the headphone jack cover when separating the back casing. The headphone jack is located on the opposite side of the antenna.

Pry the back casing off the device using a spudger. Work your way along the edges to completely separate the back casing from the device.

This step may require extra force. But too much force could break the back casing.

Remove the headphone jack cover when separating the back casing. The headphone jack is located on the opposite side of the antenna.

Step 6

              Lift the Motherboard               

• Gently lift up the motherboard. The keypad should now be exposed.

Gently lift up the motherboard. The keypad should now be exposed.

Step 7

              Disconnect the Flex Ribbon               

• Using tweezers, pull on the silver flex ribbon to disconnect it from the motherboard.

Using tweezers, pull on the silver flex ribbon to disconnect it from the motherboard.

Step 8

              Remove the Motherboard               

• Remove the motherboard from the back of the phone.

Remove the motherboard from the back of the phone.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    Michaella                     

Member since: 10/07/2014

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       USF Tampa, Team 1-6, Leahy Fall 2014                        

                                                  Member of USF Tampa, Team 1-6, Leahy Fall 2014 



                    USFT-LEAHY-F14S1G6                     


                                            6 Members                     


                                            10 Guides authored