Difficulty

Easy

Steps

8

Time Required

                          10 - 15 minutes

Sections

3

  • Battery
  • 2 steps
  • Case
  • 5 steps
  • Function Set
  • 1 step

Flags

0

  • BackSanyo VPC S1275

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Battery
  • Place your thumb on the right side of the camera over the battery door.
  • Slide the battery door to the right until the door lifts up.

Place your thumb on the right side of the camera over the battery door.

Slide the battery door to the right until the door lifts up.

1024

Step 2

  • Remove and recycle old batteries.

Remove and recycle old batteries.

Step 3

              Case
  • Remove the following six screws using the Phillips #00 screwdriver:
  • Two screws on the left side of the camera.
  • Two screws on the right side of the camera.
  • Two screws on the bottom of the camera.

Remove the following six screws using the Phillips #00 screwdriver:

Two screws on the left side of the camera.

Two screws on the right side of the camera.

Two screws on the bottom of the camera.

Step 4

  • Open the battery slot on the bottom of the camera by sliding the door to the right.
  • Remove the single 4 mm screw on the bottom right using the Phillips #00 screwdriver.

Open the battery slot on the bottom of the camera by sliding the door to the right.

Remove the single 4 mm screw on the bottom right using the Phillips #00 screwdriver.

Step 5

  • Insert a spudger in the seam at the bottom of the camera.
  • Gently separate the rear case from the front of the camera.

Insert a spudger in the seam at the bottom of the camera.

Gently separate the rear case from the front of the camera.

Step 6

  • This step is only needed for the case and logic board replacement
  • Using the Phillips #00 screwdriver, remove the single screw attached to the front casing in the top left corner. The front case should easily separate.

This step is only needed for the case and logic board replacement

Using the Phillips #00 screwdriver, remove the single screw attached to the front casing in the top left corner. The front case should easily separate.

Step 7

  • This step is only needed for the case replacement.
  • Using the Phillips #00 screwdriver, remove the screw on the inside of the battery door.
  • Slide the battery door off of the hinge.

This step is only needed for the case replacement.

Using the Phillips #00 screwdriver, remove the screw on the inside of the battery door.

Slide the battery door off of the hinge.

Step 8

              Function Set
  • Remove the function set strip by lifting it from the inside of the rear case.
  • The function strip is now free from the camera.

Remove the function set strip by lifting it from the inside of the rear case.

The function strip is now free from the camera.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 


                    Ariana Martinez

Member since: 04/15/2010

50 Reputation

                                      4 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team 24-24, Regan Spring 2010                        

                                                  Member of Cal Poly, Team 24-24, Regan Spring 2010 



                    CPSU-REGAN-S10S24G24                     


                                            4 Members                     


                                            12 Guides authored