Difficulty

Moderate

Steps

5

Time Required

                          10 minutes

Sections

2

  • Stand
  • 2 steps
  • Board Cover
  • 3 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Bullets!

Better coordination with markups and the color/type of bullets will help make this guide more clear!

Incorrect Tools

Help make this guide better by using the correct tools in images and/or text.

Needs Better Images

Better photos will improve this guide. Help out by taking, editing, or uploading new ones!

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackSceptre X9 Komodo VII

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Stand
  • Place the monitor face down.
  • Remove the four 11.5mm screws with a #2 Phillips screwdriver.
  • Remove the stand by pulling it out.

Place the monitor face down.

Remove the four 11.5mm screws with a #2 Phillips screwdriver.

Remove the stand by pulling it out.

1024

Step 2

  • Remove two 11.5mm screws with a #2 Phillips screwdriver.
  • Remove the plastic bar.

Remove two 11.5mm screws with a #2 Phillips screwdriver.

Remove the plastic bar.

Step 3

              Board Cover
  • Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

Using a #2 Phillips screwdriver, remove the six 7mm screws at the circled locations.

Step 4

  • Pry the monitor using the plastic opening tool to release the clips holding the cover on.
  • There are four clips on each side, four on the top, and one on the bottom.
  • You may hear a loud snapping noise when releasing the clips. Do not be alarmed, it is natural.
  • Once all the clips have been released, remove the cover by pulling it up.

Pry the monitor using the plastic opening tool to release the clips holding the cover on.

There are four clips on each side, four on the top, and one on the bottom.

You may hear a loud snapping noise when releasing the clips. Do not be alarmed, it is natural.

Once all the clips have been released, remove the cover by pulling it up.

Step 5

  • Using the #2 Phillips screwdriver, remove the one 6mm screw.
  • Unplug the indicated cable by pulling on the base.
  • Slide the cover toward the top of the monitor.
  • Remove the cover.

Using the #2 Phillips screwdriver, remove the one 6mm screw.

Unplug the indicated cable by pulling on the base.

Slide the cover toward the top of the monitor.

Remove the cover.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 4 other contributors 


                    Ted Hsueh

Member since: 09/20/2012

170 Reputation

                                      3 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       Cal Poly, Team 16-56, Forte Fall 2012                        

                                                  Member of Cal Poly, Team 16-56, Forte Fall 2012 



                    CPSU-FORTE-F12S16G56                     


                                            5 Members                     


                                            7 Guides authored