Sega Genesis Flashback Back Cover Replacement Repair Guide

Difficulty

Easy

Steps

Time Required

                          5 - 10 minutes

Sections

Back Cover
4 steps

Flags

BackSEGA Genesis Flashback
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Back Cover

Scratch off the right-hand side of the sticker at the center of the bottom case using the spudger until the screw is visible.
Remove this screw with the Phillips #000 screwdriver.

Scratch off the right-hand side of the sticker at the center of the bottom case using the spudger until the screw is visible.

Remove this screw with the Phillips #000 screwdriver.

1024

Step 2

Remove the two visible screws on the bottom with the Phillips #000 screwdriver.

Remove the two visible screws on the bottom with the Phillips #000 screwdriver.

Step 3

Use your fingers to peel off the four corner rubber feet on the bottom.
Use the Phillips #000 screwdriver to remove the four screws beneath the rubber feet.

Use your fingers to peel off the four corner rubber feet on the bottom.

Use the Phillips #000 screwdriver to remove the four screws beneath the rubber feet.

Step 4

Flip the case to its upright position.
Place one hand on the bottom plate of the case and one on the top plate. Gently pull apart the two plates by tilting the top plate about the front of the device. Treat the front of the device as a hinge.
Remove the back cover from the device.
Be sure not to rip the wire connection of the LED bulb that is still connected to the bottom plate.

Flip the case to its upright position.

Place one hand on the bottom plate of the case and one on the top plate. Gently pull apart the two plates by tilting the top plate about the front of the device. Treat the front of the device as a hinge.

Remove the back cover from the device.

Be sure not to rip the wire connection of the LED bulb that is still connected to the bottom plate.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 5 other contributors

                    Viet Nguyen

Member since: 04/17/2018

220 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team S24-G12, Maness Spring 2018                        

                                                  Member of Cal Poly, Team S24-G12, Maness Spring 2018 



                    CPSU-MANESS-S18S24G12                     


                                            4 Members                     


                                            10 Guides authored

Introduction#

What you need#

#

#

#

#

#

#

Team#

#

Introduction

What you need

Team