Difficulty
Easy
Steps
1
Time Required
4 - 5 minutes
Sections
- Controller Back Cover
- 1 step
Flags
0
BackSEGA Genesis Flashback
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Controller Back Cover
- Remove the screws on the back of the controller with the Phillips #000 screwdriver.
- Hold the controller with the bottom plate facing up, gently remove the top plate that is connected to the motherboard of the controller. Set the top plate aside.
- Be sure to separate the two plates with the bottom facing up, to keep the buttons from falling out.
- Place screws on magnetic project mat to avoid losing any screws.
Remove the screws on the back of the controller with the Phillips #000 screwdriver.
Hold the controller with the bottom plate facing up, gently remove the top plate that is connected to the motherboard of the controller. Set the top plate aside.
Be sure to separate the two plates with the bottom facing up, to keep the buttons from falling out.
Place screws on magnetic project mat to avoid losing any screws.
1024
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 4 other contributors
Omar Shorab
Member since: 04/23/2018
261 Reputation
2 Guides authored
Badges:
7
+4 more badges
Team
Cal Poly, Team S24-G12, Maness Spring 2018
Member of Cal Poly, Team S24-G12, Maness Spring 2018
CPSU-MANESS-S18S24G12
4 Members
10 Guides authored
