Difficulty
Moderate
Steps
6
Time Required
10 minutes
Sections
1
- Outer Case
- 6 steps
Flags
0
BackSega Genesis
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Outer Case
- Remove the six screws from the underside of the console with a Phillips #1 screwdriver.
Remove the six screws from the underside of the console with a Phillips #1 screwdriver.
1024
Step 2
- Flip the Sega Genesis upright.
Flip the Sega Genesis upright.
Step 3
- Gently lift the top casing.
- Note: the case will be connected to the main board by LED wires.
Gently lift the top casing.
Note: the case will be connected to the main board by LED wires.
Step 4
- Bend out the LED leads into vertical positions.
Bend out the LED leads into vertical positions.
Step 5
- Slide the LED wire apparatus off the lead pins.
- Note: observe which color wire corresponds with which length of pin.
Slide the LED wire apparatus off the lead pins.
Note: observe which color wire corresponds with which length of pin.
Step 6
- Separate the main board from the outer case.
Separate the main board from the outer case.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
16 other people completed this guide.
Author
with 8 other contributors
Erik Bjornstrom
Member since: 10/04/2010
805 Reputation
3 Guides authored
Badges:
12
+9 more badges
Team
Cal Poly, Team 3-29, Regan Fall 2010
Member of Cal Poly, Team 3-29, Regan Fall 2010
CPSU-REGAN-F10S3G29
4 Members
11 Guides authored
