Difficulty
Easy
Steps
3
Time Required
10 - 20 minutes
Sections
1
- Headband Pad
- 3 steps
Flags
0
BackSennheiser HD 4.50
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Headband Pad
- Extend the headphones by pulling the headband away from the base of the headphones.
- Do this to both the right and left sides of the headphones.
Extend the headphones by pulling the headband away from the base of the headphones.
Do this to both the right and left sides of the headphones.
1024
Step 2
- Use a Phillips #000 screwdriver to remove the two screws on the silver piece on either edge of the headband.
- Make sure to do this to both the right and left sides of the headphones.
- After removing the screws, slide both silver pieces down.
Use a Phillips #000 screwdriver to remove the two screws on the silver piece on either edge of the headband.
Make sure to do this to both the right and left sides of the headphones.
After removing the screws, slide both silver pieces down.
Step 3
- Grasp the headband pad firmly with your pointer finger and thumb and gently pull the pad away from the headband until the pad is fully removed.
- You may need to apply adhesive when sticking the replacement headband pad back to the headband.
Grasp the headband pad firmly with your pointer finger and thumb and gently pull the pad away from the headband until the pad is fully removed.
You may need to apply adhesive when sticking the replacement headband pad back to the headband.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Grace Singley
Member since: 02/19/2021
559 Reputation
5 Guides authored
Badges:
8
+5 more badges
Team
University of Alabama, Team S2-G1, Bedsole Spring 2021
Member of University of Alabama, Team S2-G1, Bedsole Spring 2021
UA-BEDSOLE-S21S2G1
4 Members
11 Guides authored