Difficulty

Moderate

Steps

4

Time Required

                          15 - 35 minutes

Sections

1

  • Numb Button
  • 4 steps

Flags

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

  • BackHumax IR-FOX C Set-Top Box

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Numb Button
  • Make sure the box is not plugged in before starting!
  • Remove the 5 screws holding the outer casing in place: 3 can be found on the back and 1 on either side of the box.
  • Slide the casing backwards.

Make sure the box is not plugged in before starting!

Remove the 5 screws holding the outer casing in place: 3 can be found on the back and 1 on either side of the box.

Slide the casing backwards.

1024

Step 2

  • Disconnect the front of the by lifting the 2 connectors . You can also apply extra pressure on the front from below.
  • Tilt the front forward and remove it.
  • Remove the connector by pressing the upper part of it and carefully pulling it.
  • Be carefull not to damage the cables and circuit board!

Disconnect the front of the by lifting the 2 connectors . You can also apply extra pressure on the front from below.

Tilt the front forward and remove it.

Remove the connector by pressing the upper part of it and carefully pulling it.

Be carefull not to damage the cables and circuit board!

Step 3

  • Undo the 4 screws of the front panel.
  • Locate your broken button. For instance, the third button from the left (front view), is the CH- button.

Undo the 4 screws of the front panel.

Locate your broken button. For instance, the third button from the left (front view), is the CH- button.

Step 4

  • Unsolder the push button. You can push it out or maybe use some plyers.
  • Remove the old button and insert the new one.
  • Solder the new push button on.
  • Check this link for help How To Solder and Desolder Connections

Unsolder the push button. You can push it out or maybe use some plyers.

Remove the old button and insert the new one.

Solder the new push button on.

Check this link for help How To Solder and Desolder Connections

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Yvo Kipping

Member since: 12/05/2016

101 Reputation

                                      1 Guide authored                  



                       Badges:
                       3

Team

                       Delft University of Technology, Team 1-5, Flipsen Fall 2016                        

                                                  Member of Delft University of Technology, Team 1-5, Flipsen Fall 2016 



                    TUD-FLIPSEN-F16S1G5                     


                                            3 Members                     


                                            1 Guide authored