Shark Cordless Pet Perfect Front Motor Replacement Repair Guide

Difficulty

Difficult

Steps

5

Time Required

                          25 - 45 minutes            

Sections

2

• Front Belt
• 4 steps
• Front Motor
• 1 step

Flags

0

• BackShark Cordless Pet Perfect

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Front Belt               

• Remove the two 12mm screws from the front face plate with the PH2 bit from the tool kit.

Remove the two 12mm screws from the front face plate with the PH2 bit from the tool kit.

1024

Step 2

• Once the screws are removed pull the front face plate off. This will allow access to the belt and motor.

Once the screws are removed pull the front face plate off. This will allow access to the belt and motor.

Step 3

• Lift the brush roller upwards towards you, and the brush roller should come out along with the belt.

Lift the brush roller upwards towards you, and the brush roller should come out along with the belt.

Step 4

• Remove the belt from the motor mount, and then replace with a new belt.

Remove the belt from the motor mount, and then replace with a new belt.

Step 5

              Front Motor               

• Remove the solder from both motor terminals.

Remove the solder from both motor terminals.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.                                             

Author

                                      with 5 other contributors 

                    Ashley Calkins                     

Member since: 02/02/2017

521 Reputation

                                      3 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges                           

Team

                       USF Tampa, Team 16-2, Blackwell Spring 2017                        

                                                  Member of USF Tampa, Team 16-2, Blackwell Spring 2017 



                    USFT-BLACKWELL-S17S16G2                     


                                            4 Members                     


                                            11 Guides authored                     

Jimbo - Nov 7, 2017

Reply

Well done, Ashley! You might want to note that using a solder remover is helpful.

F V - Feb 2, 2020

Reply

Where can I obtain the new motor with the plastic gear?