Difficulty

Difficult

Steps

10

Time Required

                          15 minutes

Sections

3

  • Garage Door
  • 1 step
  • Side Component
  • 4 steps
  • LED Headlight
  • 5 steps

Flags

0

  • BackShark Flex DuoClean

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Garage Door
  • Open the garage door by sliding both of the release buttons away from you.
  • Lift off the garage door.

Open the garage door by sliding both of the release buttons away from you.

Lift off the garage door.

1024

Step 2

              Side Component
  • Remove the plastic screw covering using a metal spudger by pushing the sharp side into the crevice and prying the cover out.

Remove the plastic screw covering using a metal spudger by pushing the sharp side into the crevice and prying the cover out.

Step 3

  • Turn the T10 Security Torx screwdriver counterclockwise to remove the 15mm screw.

Turn the T10 Security Torx screwdriver counterclockwise to remove the 15mm screw.

Step 4

  • Use the iFixit Opening Tool to pry the side of the vacuum open.

Use the iFixit Opening Tool to pry the side of the vacuum open.

Step 5

  • Remove the side component with your hands.

Remove the side component with your hands.

Step 6

              LED Headlight

Step 7

  • Use the nylon spudger to pry the gold, plastic cover off of the headlights.
  • Prying off the cover too aggressively may cause it to break.

Use the nylon spudger to pry the gold, plastic cover off of the headlights.

Prying off the cover too aggressively may cause it to break.

Step 8

Step 9

  • Use the metal spudger to pry off the clear, plastic cover on the LEDs.
  • Prying the cover off too aggressively may cause it to break.

Use the metal spudger to pry off the clear, plastic cover on the LEDs.

Prying the cover off too aggressively may cause it to break.

Step 10

  • Use wire cutters to detach the black cables from the LEDs on both sides.
  • Strip 1 cm off the ends of the wires, using a wire stripper.
  • Solder the exposed wires to the new LEDs.
  • Use the soldering guide in the Introduction.

Use wire cutters to detach the black cables from the LEDs on both sides.

Strip 1 cm off the ends of the wires, using a wire stripper.

Solder the exposed wires to the new LEDs.

Use the soldering guide in the Introduction.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Samantha Mickelson

Member since: 10/08/2018

496 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team S17-G5, White Fall 2018                        

                                                  Member of Cal Poly, Team S17-G5, White Fall 2018 



                    CPSU-WHITE-F18S17G5                     


                                            4 Members                     


                                            14 Guides authored