Shark Ion Robot R75 Main Brush Replacement Repair Guide

Difficulty

Very easy

Steps

3

Time Required

                          1 minute            

Sections

1

• Main Brush
• 3 steps

Flags

0

• BackShark ION Robot R75

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Step 1

              Main Brush               

• Push on the two tabs on the edge of the main brush cover and pull up to remove the cover.

Push on the two tabs on the edge of the main brush cover and pull up to remove the cover.

1024

Step 2

• Pull the main brush slightly to the right to remove it from the compartment.

Pull the main brush slightly to the right to remove it from the compartment.

Step 3

• Remove the rubber end cap indicated by the red circle.
• This step is not needed for a replacement. However, it is important for maintenance. Hair will build up in this area over time, and will cause error messages to pop up, as well as stopping the R75 from cleaning and moving.
• Inspect this component at least every six months. This time may be less if you have animals.

Remove the rubber end cap indicated by the red circle.

This step is not needed for a replacement. However, it is important for maintenance. Hair will build up in this area over time, and will cause error messages to pop up, as well as stopping the R75 from cleaning and moving.

Inspect this component at least every six months. This time may be less if you have animals.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 

                    Kyle Wilbourn                     

Member since: 01/25/2020

489 Reputation

                                      4 Guides authored                  



                       Badges:
                       10







                                                        +7 more badges                           

Team

                       Embry-Riddle Aeronautical University, Team S3-G6, Watkins Spring 2020                        

                                                  Member of Embry-Riddle Aeronautical University, Team S3-G6, Watkins Spring 2020 



                    ERAU-WATKINS-S20S3G6                     


                                            4 Members                     


                                            14 Guides authored                     

Tina Hicks - Nov 9, 2020

Reply

My shark ion stopped working after about 6 months and it started giving an error on the brush. I cleaned my vacuum pretty regularly, at least once a week. I ordered a replacement brush and it still hasn’t fixed it. Do you have any other suggestions?