Shark Ion Robot S87 Bumper Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          10 - 15 minutes

Sections

Bumper
3 steps

Flags

BackShark ION Robot S87
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Bumper

Flip the Shark ION Robot S87 on its underside so that the bumper and its screws are facing upwards.
Use a Hex 2mm screwdriver to remove the five 8mm screws from the bumper.

Flip the Shark ION Robot S87 on its underside so that the bumper and its screws are facing upwards.

Use a Hex 2mm screwdriver to remove the five 8mm screws from the bumper.

1024

Step 2

Once all screws have been removed lift the thin side of the bumper upwards to remove it from the robot.
Lift the robot up so that the larger part of the bumper stays on the floor and is removed.
Once both pieces of the bumper have been removed, you can place the robot back down.

Once all screws have been removed lift the thin side of the bumper upwards to remove it from the robot.

Lift the robot up so that the larger part of the bumper stays on the floor and is removed.

Once both pieces of the bumper have been removed, you can place the robot back down.

Step 3

Check all sensors and remove any that may have debris in front of it.
You may also swap out the bumper for another depending on whether or not it is broken.

Check all sensors and remove any that may have debris in front of it.

You may also swap out the bumper for another depending on whether or not it is broken.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors

                    Adeel Ahmad

Member since: 01/14/2020

232 Reputation

                                      2 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges

Team

                       York University, Team S1-G7, Woodhouse Winter 2020                        

                                                  Member of York University, Team S1-G7, Woodhouse Winter 2020 



                    YORK-WOODHOUSE-W20S1G7                     


                                            3 Members                     


                                            12 Guides authored

Introduction#

What you need#

#

#

#

#

#

Team#

#

Introduction

What you need

Team