Shark Ion Robot S87 Drive Wheel Replacement Repair Guide

Difficulty

Easy

Steps

3

Time Required

                          5 minutes            

Sections

1

• Drive Wheel
• 3 steps

Flags

0

• BackShark ION Robot S87

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Drive Wheel               

• Make sure device is turned off before attempting this replacement.
• Remove three 13mm screws using a T15 Torx screwdriver.
• Remove one 15mm screw using a Phillips #1 screwdriver.
• Remove one final 15mm Phillips #1 screw.

Make sure device is turned off before attempting this replacement.

Remove three 13mm screws using a T15 Torx screwdriver.

Remove one 15mm screw using a Phillips #1 screwdriver.

Remove one final 15mm Phillips #1 screw.

1024

Step 2

• Carefully lift the wheel assembly out of the housing, making sure not to damage its connecting wire.

Carefully lift the wheel assembly out of the housing, making sure not to damage its connecting wire.

Step 3

• Disconnect the wire carefully from the wheel assembly by pinching and pulling away from it.

Disconnect the wire carefully from the wheel assembly by pinching and pulling away from it.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 1 other contributor 

                    Trevor Davies                     

Member since: 01/14/2020

270 Reputation

                                      2 Guides authored                  



                       Badges:
                       4







                                                        +1 more badge                           

Team

                       York University, Team S1-G7, Woodhouse Winter 2020                        

                                                  Member of York University, Team S1-G7, Woodhouse Winter 2020 



                    YORK-WOODHOUSE-W20S1G7                     


                                            3 Members                     


                                            12 Guides authored                     

DovieAndiSeTova - Jul 22, 2020

Reply

Dude you made my day. Cost me 14 bucks for a torx set and fixed my little cleaning buddy. All it needed was to be blown out with compressed air and plugged back in. THANK YOU!!!