Difficulty
Moderate
Steps
9
Time Required
15 minutes
Sections
2
- Roller Brush Belt
- 8 steps
- Roller Brush
- 1 step
Flags
1
Featured Student Guide
This guide has been the hard work of our awesome students and is found to be exceptionally cool by the iFixit staff.
BackShark Navigator Lift-Away Deluxe NV360
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Roller Brush Belt
- Lay the vacuum down by hand and locate the roller brush underneath the vacuum cleaner.
Lay the vacuum down by hand and locate the roller brush underneath the vacuum cleaner.
1024
Step 2
- Insert the metal spudger between the inside side of the wheel and the plastic body.
- Push the metal spudger away from you to pop the wheels out.
- Repeat the step to remove the other wheel on the other side.
Insert the metal spudger between the inside side of the wheel and the plastic body.
Push the metal spudger away from you to pop the wheels out.
Repeat the step to remove the other wheel on the other side.
Step 3
- Remove the six 15mm screws using the PH1 screwdriver.
Remove the six 15mm screws using the PH1 screwdriver.
Step 4
- Move the blue fulcrum connecting the bottom and the main body of the vacuum cleaner back and forth to loosen up crevice between the two halves of the roller brush enclosure.
Move the blue fulcrum connecting the bottom and the main body of the vacuum cleaner back and forth to loosen up crevice between the two halves of the roller brush enclosure.
Step 5
- Insert the plastic opening tool into the crevice between the blue and the dark grey plastic frames enclosing the roller brush.
- Apply an outward force throughout and all around the gap in order to separate the two plastic frames.
Insert the plastic opening tool into the crevice between the blue and the dark grey plastic frames enclosing the roller brush.
Apply an outward force throughout and all around the gap in order to separate the two plastic frames.
Step 6
- Lift the grey frame off the bottom of the vacuum cleaner with your hands and place it on a flat surface.
Lift the grey frame off the bottom of the vacuum cleaner with your hands and place it on a flat surface.
Step 7
- Lift the roller brush slightly upwards using your hand.
- Take one side of the black roller brush belt off by pulling it over the end of the roller brush with your other hand.
Lift the roller brush slightly upwards using your hand.
Take one side of the black roller brush belt off by pulling it over the end of the roller brush with your other hand.
Step 8
- Remove the roller brush belt with your hands by sliding it of the end of the motor.
Remove the roller brush belt with your hands by sliding it of the end of the motor.
Step 9
Roller Brush
- Remove the roller brush from the plastic frame using your hands by lifting it away.
Remove the roller brush from the plastic frame using your hands by lifting it away.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
9 other people completed this guide.
Author
with 5 other contributors
Elena Postupalskaya
Member since: 10/02/2017
1,039 Reputation
6 Guides authored
Badges:
14
+11 more badges
Team
Cal Poly, Team S15-G2, Livingston Fall 2017
Member of Cal Poly, Team S15-G2, Livingston Fall 2017
CPSU-LIVINGSTON-F17S15G2
3 Members
14 Guides authored
Sean E. Belew - Apr 12, 2018
Reply
What is the part number for the roller brush?
benjpatt - Feb 9, 2019
Reply
what is the part number for the motor and motherboard
Ace - Apr 20, 2021
Reply
Worst screw types. You suck
