Difficulty
Moderate
Steps
11
Time Required
10 minutes
Sections
2
- Head Shell
- 8 steps
- Brush Head
- 3 steps
Flags
0
BackShark Navigator
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Head Shell
- Detach the hose connected on the bottom of the vacuum by pulling it out of the casing.
Detach the hose connected on the bottom of the vacuum by pulling it out of the casing.
1024
Step 2
- Lay the vacuum on its side.
- Press in the black, rubberish button located on the back of the vacuum to detach the vacuum head from the body.
Lay the vacuum on its side.
Press in the black, rubberish button located on the back of the vacuum to detach the vacuum head from the body.
Step 3
- Flip over the vacuum head so the brush head is facing up.
Flip over the vacuum head so the brush head is facing up.
Step 4
- Remove the small front wheels with a metal spudger by inserting the metal spudger in front of the wheel and slowly prying up. This will free the wheel and reveal the screw beneath it.
- Repeat this for the other wheel.
Remove the small front wheels with a metal spudger by inserting the metal spudger in front of the wheel and slowly prying up. This will free the wheel and reveal the screw beneath it.
Repeat this for the other wheel.
Step 5
- Remove the two 18mm screws with a JIS 1 screwdriver.
Remove the two 18mm screws with a JIS 1 screwdriver.
Step 6
- Remove the four 18mm screws located on the top corners and the bottom/middle of the vacuum head using a JIS 1 screwdriver.
Remove the four 18mm screws located on the top corners and the bottom/middle of the vacuum head using a JIS 1 screwdriver.
Step 7
- Remove the two 18mm screws located on the inside of the large wheels using a JIS 1 screwdriver.
Remove the two 18mm screws located on the inside of the large wheels using a JIS 1 screwdriver.
Step 8
- Remove the plastic cover by prying the plastic cover up using a plastic opening tool.
- Prying in multiple locations may be necessary to create separation.
Remove the plastic cover by prying the plastic cover up using a plastic opening tool.
Prying in multiple locations may be necessary to create separation.
Step 9
Brush Head
- Remove the belt, found on the right hand side, from the motor gear.
Remove the belt, found on the right hand side, from the motor gear.
Step 10
- Lift up the brush head from the plastic housing, slight force may be needed.
- Remove the band from the brush head.
Lift up the brush head from the plastic housing, slight force may be needed.
Remove the band from the brush head.
Step 11
- Remove the plastic caps on each end of the brush head.
Remove the plastic caps on each end of the brush head.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 3 other contributors
Suzie
Member since: 10/02/2017
515 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team S4-G6, Livingston Fall 2017
Member of Cal Poly, Team S4-G6, Livingston Fall 2017
CPSU-LIVINGSTON-F17S4G6
3 Members
12 Guides authored
brushed1 - Dec 15, 2020
Reply
Thank you very much Suzie, posting the exact information needed visually to boot is
just what I needed to replace my brush roller. Manuals usually frustrate me as well as over chatty
tutorials that get me lost.. Thanks again ! Happy Holidays ! Leigh Clement
