Difficulty

Easy

Steps

8

Time Required

                          7 minutes

Sections

1

  • Head Shell
  • 8 steps

Flags

0

  • BackShark Navigator

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Head Shell
  • Detach the hose connected on the bottom of the vacuum by pulling it out of the casing.

Detach the hose connected on the bottom of the vacuum by pulling it out of the casing.

1024

Step 2

  • Lay the vacuum on its side.
  • Press in the black, rubberish button located on the back of the vacuum to detach the vacuum head from the body.

Lay the vacuum on its side.

Press in the black, rubberish button located on the back of the vacuum to detach the vacuum head from the body.

Step 3

  • Flip over the vacuum head so the brush head is facing up.

Flip over the vacuum head so the brush head is facing up.

Step 4

  • Remove the small front wheels with a metal spudger by inserting the metal spudger in front of the wheel and slowly prying up. This will free the wheel and reveal the screw beneath it.
  • Repeat this for the other wheel.

Remove the small front wheels with a metal spudger by inserting the metal spudger in front of the wheel and slowly prying up. This will free the wheel and reveal the screw beneath it.

Repeat this for the other wheel.

Step 5

  • Remove the two 18mm screws with a JIS 1 screwdriver.

Remove the two 18mm screws with a JIS 1 screwdriver.

Step 6

  • Remove the four 18mm screws located on the top corners and the bottom/middle of the vacuum head using a JIS 1 screwdriver.

Remove the four 18mm screws located on the top corners and the bottom/middle of the vacuum head using a JIS 1 screwdriver.

Step 7

  • Remove the two 18mm screws located on the inside of the large wheels using a JIS 1 screwdriver.

Remove the two 18mm screws located on the inside of the large wheels using a JIS 1 screwdriver.

Step 8

  • Remove the plastic cover by prying the plastic cover up using a plastic opening tool.
  • Prying in multiple locations may be necessary to create separation.

Remove the plastic cover by prying the plastic cover up using a plastic opening tool.

Prying in multiple locations may be necessary to create separation.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Suzie

Member since: 10/02/2017

515 Reputation

                                      4 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team S4-G6, Livingston Fall 2017                        

                                                  Member of Cal Poly, Team S4-G6, Livingston Fall 2017 



                    CPSU-LIVINGSTON-F17S4G6                     


                                            3 Members                     


                                            12 Guides authored

Diane Snelling - Feb 21, 2021

Reply

I have been doing exactly what the steps require but have not been able to remove the cover. Each time I am able to release one side the other side snaps back and the fixit tools fall out or fall inside.

Please give me any suggestions to accomplish removing the cover. Thank you.