Difficulty
Moderate
Steps
12
Time Required
10 minutes
Sections
2
- Head Shell
- 8 steps
- Motor
- 4 steps
Flags
0
BackShark Navigator
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Head Shell
- Detach the hose connected on the bottom of the vacuum by pulling it out of the casing.
Detach the hose connected on the bottom of the vacuum by pulling it out of the casing.
1024
Step 2
- Lay the vacuum on its side.
- Press in the black, rubberish button located on the back of the vacuum to detach the vacuum head from the body.
Lay the vacuum on its side.
Press in the black, rubberish button located on the back of the vacuum to detach the vacuum head from the body.
Step 3
- Flip over the vacuum head so the brush head is facing up.
Flip over the vacuum head so the brush head is facing up.
Step 4
- Remove the small front wheels with a metal spudger by inserting the metal spudger in front of the wheel and slowly prying up. This will free the wheel and reveal the screw beneath it.
- Repeat this for the other wheel.
Remove the small front wheels with a metal spudger by inserting the metal spudger in front of the wheel and slowly prying up. This will free the wheel and reveal the screw beneath it.
Repeat this for the other wheel.
Step 5
- Remove the two 18mm screws with a JIS 1 screwdriver.
Remove the two 18mm screws with a JIS 1 screwdriver.
Step 6
- Remove the four 18mm screws located on the top corners and the bottom/middle of the vacuum head using a JIS 1 screwdriver.
Remove the four 18mm screws located on the top corners and the bottom/middle of the vacuum head using a JIS 1 screwdriver.
Step 7
- Remove the two 18mm screws located on the inside of the large wheels using a JIS 1 screwdriver.
Remove the two 18mm screws located on the inside of the large wheels using a JIS 1 screwdriver.
Step 8
- Remove the plastic cover by prying the plastic cover up using a plastic opening tool.
- Prying in multiple locations may be necessary to create separation.
Remove the plastic cover by prying the plastic cover up using a plastic opening tool.
Prying in multiple locations may be necessary to create separation.
Step 9
Motor
- Locate the motor on the top right corner of the vacuum head shell.
Locate the motor on the top right corner of the vacuum head shell.
Step 10
- Remove the belt from the motor gear by sliding the belt to the right.
Remove the belt from the motor gear by sliding the belt to the right.
Step 11
- Remove the white metal wire connector from the motor.
- The white cable is positive.
Remove the white metal wire connector from the motor.
The white cable is positive.
Step 12
- Remove the black metal wire connector from the motor.
- The black cable is negative.
Remove the black metal wire connector from the motor.
The black cable is negative.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
4 other people completed this guide.
Author
with 3 other contributors
Suzie
Member since: 10/02/2017
515 Reputation
4 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team S4-G6, Livingston Fall 2017
Member of Cal Poly, Team S4-G6, Livingston Fall 2017
CPSU-LIVINGSTON-F17S4G6
3 Members
12 Guides authored
Michael De La Rosa - Jun 15, 2019
Reply
Where does one buy the replacement motor?
Clive Kingscote - Nov 20, 2020
Reply
Where can I get spares??
ck
