Difficulty

Difficult

Steps

5

Time Required

                          15 minutes

Sections

2

  • Roller Brush Compartment
  • 3 steps
  • Motherboard
  • 2 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackShark Navigator Lift-Away Pro

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Roller Brush Compartment
  • Pop out the two small wheels located on the front end of the bottom of the roller brush compartment.

Pop out the two small wheels located on the front end of the bottom of the roller brush compartment.

1024

Step 2

  • Remove the 10 Phillips screws located on the bottom of the roller brush compartment. (Two of these screws are located under the wheels from the previous step.)
  • The screws have varying lengths, so keep track of where each one goes for reassembly.

Remove the 10 Phillips screws located on the bottom of the roller brush compartment. (Two of these screws are located under the wheels from the previous step.)

The screws have varying lengths, so keep track of where each one goes for reassembly.

Step 3

  • Remove the white plastic cover to expose the roller compartment underneath.

Remove the white plastic cover to expose the roller compartment underneath.

Step 4

              Motherboard
  • There is one screw at the edge of the circuit board. Unscrew the circuit board before attempting to take it out.

There is one screw at the edge of the circuit board. Unscrew the circuit board before attempting to take it out.

Step 5

  • Take out the circuit board and replace with a new one. It may be better to allow a professional to re-wire the circuit board to the vacuum.

Take out the circuit board and replace with a new one. It may be better to allow a professional to re-wire the circuit board to the vacuum.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 3 other contributors 


                    Mara

Member since: 03/27/2015

469 Reputation

                                      2 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       UMass Dartmouth, Team 5-4, Kish Spring 2015                        

                                                  Member of UMass Dartmouth, Team 5-4, Kish Spring 2015 



                    UMASSD-KISH-S15S5G4                     


                                            4 Members                     


                                            16 Guides authored

jacob - Apr 25, 2016

Reply

Hi ..well done with the instructions.However I do have a Shark rotator vacuum NV501 .Unfortunately the motor on the brush is not working ,so I assume the motor is burnt.My request where could I find a replacement of the motor.I have searched a lot sites online but could not find a place to rebuild nor stock the same motor.Any help would be appreciated.Thank you…..To forward any information please do so on my email jacob.brown at hotmail.com thank you….

dylananon - Jun 15, 2016

Reply

I couldn’t figure out how to remove the bottom plate, your guide helped by informing me the last two screws are located under the little wheels. Thank you!

mardit - Aug 18, 2016

Reply

When I had mine apart, two black rectangle magnet fell out, I can’t figure out where the came from.

bjolivares1055 - Jan 22, 2017

I had the same problem with the magnets - where do they go>

Liz - Mar 13, 2018

Reply

Also having problem locating both mother board and brush roller motor. Where can i purchase them?