Shark Pet Perfect Ii Battery Replacement Repair Guide

Difficulty

Easy

Steps

4

Time Required

                          5 minutes            

Sections

1

• Battery
• 4 steps

Flags

0

• BackShark Pet Perfect II

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Battery               

• Locate and remove the 7.5mm Philips screw holding the battery cover in place on bottom of the vacuum.

Locate and remove the 7.5mm Philips screw holding the battery cover in place on bottom of the vacuum.

1024

Step 2

• Once the cover is removed, slide the plastic retaining bracket down and pull out to remove.

Once the cover is removed, slide the plastic retaining bracket down and pull out to remove.

Step 3

• Pull the battery out of the compartment.
• Carefully disconnect the quick disconnect couplers.
• The Couplers may be tightly secured so it may be necessary to use a small flat device to carefully loosen the coupler.
• Be sure to use an ESD safe tool like the nylon spudger when working with wires and batteries—this will prevent injury and/or device damage.

Pull the battery out of the compartment.

Carefully disconnect the quick disconnect couplers.

The Couplers may be tightly secured so it may be necessary to use a small flat device to carefully loosen the coupler.

Be sure to use an ESD safe tool like the nylon spudger when working with wires and batteries—this will prevent injury and/or device damage.

Step 4

• Completely remove the old battery from the vacuum .

Completely remove the old battery from the vacuum .

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.                                             

Attached Documents

• manual-SV780.pdf
• PDF - 384.59 kb
• View

manual-SV780.pdf

PDF - 384.59 kb

Author

                                      with 3 other contributors 

                    Christine Robles                     

Member since: 06/27/2017

110 Reputation

                                      1 Guide authored                  



                       Badges:
                       8





                                                        +5 more badges                           

Team

                       UW Tacoma, Team S1-G5, Liner Summer 2017                        

                                                  Member of UW Tacoma, Team S1-G5, Liner Summer 2017 



                    UWT-LINER-SU17S1G5                     


                                            4 Members                     


                                            8 Guides authored                     

Adalyn Etelamaki - Sep 1, 2019

Reply

Removed the single screw but cover will not come off. What do you do?

PradSim Promo Ads - Feb 3, 2020

Reply

Just tried it. The cover is a bit hard. Gold the vacuum at an angle and slightly push the notch on the cover with a flat screwdriver, it should come out.

ligthelf - Jun 14, 2020

Reply

Will it run on cord only

Jim DeCamp - Dec 4, 2020

NO. Requires batteries.

Jim DeCamp - Dec 4, 2020

Reply

1.) Mine was much harder to disassemble, took considerable force.

2.) No one sells form, fit and function replacement batteries, including Shark

3.) The available replacement are much smaller in volume, and hence power, and require padding or they will rattle.