Difficulty

Moderate

Steps

7

Time Required

                          5 - 10 minutes

Sections

2

  • Shark Professional Steam Pocket Mop Front Panel Disassembly
  • 6 steps
  • Control Panel
  • 1 step

Flags

0

  • BackShark Professional Steam Pocket Mop

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Shark Professional Steam Pocket Mop Front Panel Disassembly
  • Unwrap the power cord from the handle.
  • Remove the 56.0 mm Phillips head #2 screw located above the water tank cap.
  • Pull the handle to separate it from the body.

Unwrap the power cord from the handle.

Remove the 56.0 mm Phillips head #2 screw located above the water tank cap.

Pull the handle to separate it from the body.

1024

Step 2

  • Remove the three 12.0 mm Phillips head #2 screws where the handle connects to the body.
  • Remove the plastic cap.

Remove the three 12.0 mm Phillips head #2 screws where the handle connects to the body.

Remove the plastic cap.

Step 3

  • Remove the three 16.0 mm T10 Torx screws near the top of the body and remove the water tank cap.
  • The third screw is directly on other side of the bottom screw in the photo.

Remove the three 16.0 mm T10 Torx screws near the top of the body and remove the water tank cap.

The third screw is directly on other side of the bottom screw in the photo.

Step 4

  • Remove steam control button cover with a metal spudger.
  • Remove the two 12.0 mm Phillips head #2 screws underneath.
  • Remove the plastic rim with clear plastic cover.

Remove steam control button cover with a metal spudger.

Remove the two 12.0 mm Phillips head #2 screws underneath.

Remove the plastic rim with clear plastic cover.

Step 5

  • Remove the Shark logo decal on the front of body using a metal spudger.
  • Remove the two 12.0 mm Phillips head #2 screws underneath.
  • Pull out the plastic cover to remove.

Remove the Shark logo decal on the front of body using a metal spudger.

Pull out the plastic cover to remove.

Step 6

  • Pop off the grey front plate to expose the control panel and screws necessary to open mop body.

Pop off the grey front plate to expose the control panel and screws necessary to open mop body.

Step 7

              Control Panel
  • Remove the two 12.0 mm Phillips head #2 screws. Disconnect the control board.
  • Disconnect the control board

Remove the two 12.0 mm Phillips head #2 screws. Disconnect the control board.

Disconnect the control board

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Brett Wilson

Member since: 02/12/2018

926 Reputation

                                      6 Guides authored                  



                       Badges:
                       13







                                                        +10 more badges

Team

                       USF Tampa, Team S15-G1, Boczar Spring 2018                        

                                                  Member of USF Tampa, Team S15-G1, Boczar Spring 2018 



                    USFT-BOCZAR-S18S15G1                     


                                            4 Members                     


                                            14 Guides authored