Shark Rocket Hv381 Led Replacement Repair Guide

Difficulty

Moderate

Steps

5

Time Required

                          5 - 20 minutes            

Sections

2

• Roller
• 2 steps
• LED
• 3 steps

Flags

0

• BackShark Rocket HV381

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Roller               

• On the right-bottom of the body, pull down the black switch. You will hear an audible click when you detach the body from the vacuum head.

On the right-bottom of the body, pull down the black switch. You will hear an audible click when you detach the body from the vacuum head.

1024

Step 2

• Laying the vacuum head on the its right side, push the orange “Eject Roller” switch down. The Roller can now be removed with ease.

Laying the vacuum head on the its right side, push the orange “Eject Roller” switch down. The Roller can now be removed with ease.

Step 3

              LED               

• On the back of the vacuum head, located near the bottom, should be a row of screws. Using the T15 Screwdriver, remove all the screws on the bottom and the sides.

On the back of the vacuum head, located near the bottom, should be a row of screws. Using the T15 Screwdriver, remove all the screws on the bottom and the sides.

Step 4

• On the top side of the vacuum head, where the LED is located, use the Small Flathead screwdriver to pry open the cover. There should be no resistance.

On the top side of the vacuum head, where the LED is located, use the Small Flathead screwdriver to pry open the cover. There should be no resistance.

Step 5

• Picking the LED from the side, pull upwards to unwind the wires from their tracks.
• Make sure that you are gentle because the wires are very fragile. One strong pull could easily snap them from the LED.

Picking the LED from the side, pull upwards to unwind the wires from their tracks.

Make sure that you are gentle because the wires are very fragile. One strong pull could easily snap them from the LED.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Dandre Porter                     

Member since: 08/22/2017

528 Reputation

                                      5 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       Arkansas State University, Team S1-G5, Chamberlain Fall 2017                        

                                                  Member of Arkansas State University, Team S1-G5, Chamberlain Fall 2017 



                    ARSU-CHAMBERLAIN-F17S1G5                     


                                            3 Members                     


                                            10 Guides authored