Difficulty

Easy

Steps

5

Time Required

                          2 - 5 minutes

Sections

3

  • Brushroll
  • 2 steps
  • Dust Cup
  • 2 steps
  • Back Panel Screws
  • 1 step

Flags

0

  • BackShark Rocket Powerhead AH401

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Brushroll
  • Ensure the device is turned off and unplugged from any power source before beginning work.
  • Locate the two tabs with white arrows on them. They are located on either side of the brushroll cover.
  • Slide the tabs away from the center of the vacuum to unlock the brushroll cover.
  • Lift the brushroll cover upward.

Ensure the device is turned off and unplugged from any power source before beginning work.

Locate the two tabs with white arrows on them. They are located on either side of the brushroll cover.

Slide the tabs away from the center of the vacuum to unlock the brushroll cover.

Lift the brushroll cover upward.

1024

Step 2

  • Lift the brushroll out by pulling the tab labeled “pull”.

Lift the brushroll out by pulling the tab labeled “pull”.

Step 3

              Dust Cup
  • Ensure the device is turned off and unplugged from any power source before beginning work.
  • Push down on the dust can lever to release the dust can in order to get to the filter grill.

Push down on the dust can lever to release the dust can in order to get to the filter grill.

Step 4

  • Remove the dust cup by lifting it off the dock.

Remove the dust cup by lifting it off the dock.

Step 5

              Back Panel Screws
  • Flip the device over so that the bottom is face up.
  • Remove the eight screws shown by rotating counter-clockwise with a T15 Torx screwdriver.
  • Two 14 mm Torx screws
  • Two 16 mm Torx screws
  • Four 21 mm Torx screws

Flip the device over so that the bottom is face up.

Remove the eight screws shown by rotating counter-clockwise with a T15 Torx screwdriver.

Two 14 mm Torx screws

Two 16 mm Torx screws

Four 21 mm Torx screws

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors 


                    Toan Pham

Member since: 01/24/2018

260 Reputation

                                      3 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       Cal Poly, Team S19-G3, Livingston Winter 2018                        

                                                  Member of Cal Poly, Team S19-G3, Livingston Winter 2018 



                    CPSU-LIVINGSTON-W18S19G3                     


                                            4 Members                     


                                            18 Guides authored