Difficulty
Moderate
Steps
6
Time Required
15 - 20 minutes
Sections
1
- Belt
- 6 steps
Flags
Better Introduction
Improve this guide by completing or revising its introduction.
BackShark Vacuum
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Belt
- Flip the vacuum on its right side.
Flip the vacuum on its right side.
1024
Step 2
- Turn the T10 Security Bit screwdriver counterclockwise to remove the 15mm screw.
Turn the T10 Security Bit screwdriver counterclockwise to remove the 15mm screw.
Step 3
- Turn the vacuum face down.
- Turn the T10 Security Bit screwdriver counterclockwise to remove the 15mm screw.
Turn the vacuum face down.
Step 4
- Use a spudger to pry the side of the vacuum open.
Use a spudger to pry the side of the vacuum open.
Step 5
- Use a spudger to pry the old belt away from the two gears.
- The new belt will be tight and difficult to put back on. In order to reinstall, place the belt on the brushroll, then rotate the brushroll a couple rotations to make sure the belt is aligned correctly.
Use a spudger to pry the old belt away from the two gears.
The new belt will be tight and difficult to put back on. In order to reinstall, place the belt on the brushroll, then rotate the brushroll a couple rotations to make sure the belt is aligned correctly.
Step 6
- Repeat on the other side of the vacuum.
Repeat on the other side of the vacuum.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 1 other contributor
Nadia Martinez
Member since: 04/15/2021
133 Reputation
1 Guide authored
Badges:
3
Team
CSU Los Angeles, Team S1-G4, Harris Spring 2021
Member of CSU Los Angeles, Team S1-G4, Harris Spring 2021
CSULA-HARRIS-S21S1G4
1 Member
1 Guide authored
