Difficulty

Moderate

Steps

5

Time Required

Suggest a time??

Sections

1

  • Heat Plate
  • 5 steps

Flags

2

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackShark Ultimate Professional

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Heat Plate
  • Remove the two screws at the back of the iron.
  • Remove the back cover piece.
  • Make sure iron is unplugged and cooled off.

Remove the two screws at the back of the iron.

Remove the back cover piece.

Make sure iron is unplugged and cooled off.

1024

Step 2

  • Remove the two screws holding the white clamp to the iron.
  • Remove the two screws holding the black wires to the body of the iron.
  • Removing the left black wire will also free the red wire, attached by the same screw.

Remove the two screws holding the white clamp to the iron.

Remove the two screws holding the black wires to the body of the iron.

Removing the left black wire will also free the red wire, attached by the same screw.

Step 3

  • Pull the split end of the power cord upward through the ball joint of the iron.
  • Set aside power cord.

Pull the split end of the power cord upward through the ball joint of the iron.

Set aside power cord.

Step 4

  • Remove remaining screws that hold a wire on the bottom (brown and blue).
  • Unscrew from left to right.
  • Unclip the black adapter piece on the bottom right.
  • Wires order (from left to right): Brown, Blue, Red, Black

Remove remaining screws that hold a wire on the bottom (brown and blue).

Unscrew from left to right.

Unclip the black adapter piece on the bottom right.

Wires order (from left to right): Brown, Blue, Red, Black

Step 5

  • Remove two screws (left and right) affixed to circuit board.

Remove two screws (left and right) affixed to circuit board.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      3 other people completed this guide.

Author

                                      with 3 other contributors 


                    Drew Carff

Member since: 10/23/2017

868 Reputation

                                      5 Guides authored                  



                       Badges:
                       14







                                                        +11 more badges

Team

                       USF Tampa, Team S1-G4, Leahy Fall 2017                        

                                                  Member of USF Tampa, Team S1-G4, Leahy Fall 2017 



                    USFT-LEAHY-F17S1G4                     


                                            3 Members                     


                                            10 Guides authored