Difficulty

Moderate

Steps

6

Time Required

Suggest a time??

Sections

2

  • Brush Roller
  • 1 step
  • Brush Roller Belt
  • 5 steps

Flags

4

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Inconsistent Images

Updating the images on this guide to be more consistent with the prerequisites would increase its awesomeness.

Better Introduction

Improve this guide by completing or revising its introduction.

Missing Details

Some of this guide’s details are missing. Help users by adding tools, difficulty, or time.

  • BackShark Vertex Pro IZ682H

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Brush Roller
  • Detach the power nozzle from the vacuum and turn it so the right side is facing you. Pull down the blue tab to the direction where the arrow is facing.
  • The brush roller should now pop out.
  • Putting the brush roller in again does not require pulling the blue tab. It should pop in with no problem.

Detach the power nozzle from the vacuum and turn it so the right side is facing you. Pull down the blue tab to the direction where the arrow is facing.

The brush roller should now pop out.

Putting the brush roller in again does not require pulling the blue tab. It should pop in with no problem.

1024

Step 2

              Brush Roller Belt
  • Turn the three plastic locks to the unlocked position and remove the crevice tool.
  • Use T9 and T15 screwdrivers to remove the seven screws.

Turn the three plastic locks to the unlocked position and remove the crevice tool.

Use T9 and T15 screwdrivers to remove the seven screws.

Step 3

  • Use an opening tool on the edges of the casing and pull off the thin plastic coverings on both sides.
  • Expect to hear snapping noises.
  • Pull the plastic coverings off the powerhead.

Use an opening tool on the edges of the casing and pull off the thin plastic coverings on both sides.

Expect to hear snapping noises.

Pull the plastic coverings off the powerhead.

Step 4

  • Remove the six screws using a T15 Torx security screwdriver.
  • Remove the plastic headcover.

Remove the six screws using a T15 Torx security screwdriver.

Remove the plastic headcover.

Step 5

  • Remove the seven screws using the T10 and T15 Torx security screwdriver.
  • Lift the covering and motor assembly enough to see the belt.

Remove the seven screws using the T10 and T15 Torx security screwdriver.

Lift the covering and motor assembly enough to see the belt.

Step 6

  • Remove the belt and power nozzle.
  • When reinstalling, be sure the belt is tightly secured around the gear grooves.

Remove the belt and power nozzle.

When reinstalling, be sure the belt is tightly secured around the gear grooves.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Tyree Brooks

Member since: 10/26/2022

483 Reputation

                                      5 Guides authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       UMass Dartmouth, Team 3-2, Botvin Fall 2022                        

                                                  Member of UMass Dartmouth, Team 3-2, Botvin Fall 2022 



                    UMASSD-BOTVIN-F22S3G2                     


                                            3 Members                     


                                            5 Guides authored