Sharp Aquos Crystal Usb Port Replacement Repair Guide

Difficulty

Moderate

Steps

6

Time Required

                          10 - 15 minutes            

Sections

2

• Back Panel
• 1 step
• USB Port
• 5 steps

Flags

0

• BackSharp Aquos

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

This guide will take tell you what tools you need and how to open your device and get to the USB component.

What you need

Step 1

              Back Panel               

• Peel back the back cover of the phone from the access point to remove it. It should come off easily using your hands.

Peel back the back cover of the phone from the access point to remove it. It should come off easily using your hands.

1024

Step 2

              USB Port               

• Remove seven 3mm Star #5 screws shown in the picture with a screwdriver.
• Remove two 3.5mm Star #5 screws shown in the picture with a screwdriver.
• Remove two 5mm Star #5 screws shown in the picture with a screwdriver.

Remove seven 3mm Star #5 screws shown in the picture with a screwdriver.

Remove two 3.5mm Star #5 screws shown in the picture with a screwdriver.

Remove two 5mm Star #5 screws shown in the picture with a screwdriver.

Step 3

• Pry open the back panel using a plastic opening tool. Do this around the edges until you are able to lift it off.

Pry open the back panel using a plastic opening tool. Do this around the edges until you are able to lift it off.

Step 4

• Disconnect the wire by lifting it up with a plastic opening tool.

Disconnect the wire by lifting it up with a plastic opening tool.

Step 5

• To disconnect the cable, use the tip of a spudger or your fingernail to flip up the small retaining flap. Then, you can safely pull the ribbon cable out.

To disconnect the cable, use the tip of a spudger or your fingernail to flip up the small retaining flap. Then, you can safely pull the ribbon cable out.

Step 6

• After removing the wires, carefully snap out the usb port with your hands. It is held down by some plastic clips, so some force may be needed.

After removing the wires, carefully snap out the usb port with your hands. It is held down by some plastic clips, so some force may be needed.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.                                             

Author

                                      with 2 other contributors 

                    Felicia Imbriano                     

Member since: 03/08/2016

1,169 Reputation

                                      8 Guides authored                  



                       Badges:
                       24







                                                        +21 more badges                           

Team

                       UMass Dartmouth, Team 7-4, Catania Spring 2016                        

                                                  Member of UMass Dartmouth, Team 7-4, Catania Spring 2016 



                    UMASSD-CATANIA-S16S7G4                     


                                            3 Members                     


                                            24 Guides authored