Difficulty
Difficult
Steps
6
Time Required
15 - 30 minutes
Sections
1
- Digitizer/Screen
- 6 steps
Flags
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackSharp FX
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Digitizer/Screen
- Remove - Back,microSD,battery,sim
- Remove black rubber screw covers on back of display.
- Remove 000 phillips screws (4) from top of display.
Remove - Back,microSD,battery,sim
Remove black rubber screw covers on back of display.
Remove 000 phillips screws (4) from top of display.
1024
Step 2
- Remove 3 small silver screws from battery area.
- Remove 2 Torx t-7’s by MicroSD slot.
- After screws are removed you can detach screen.
Remove 3 small silver screws from battery area.
Remove 2 Torx t-7’s by MicroSD slot.
After screws are removed you can detach screen.
Step 3
- Remove 4 additional 000 phillips screws from display.
- Using some heat,spudger,frce pry away the broken display from the frame.
- Use extreme caution the actual display is very fragile.
Remove 4 additional 000 phillips screws from display.
Using some heat,spudger,frce pry away the broken display from the frame.
Use extreme caution the actual display is very fragile.
Step 4
- Remove connector for digitizer
- replace connector with new digitizer and rebuild.
Remove connector for digitizer
replace connector with new digitizer and rebuild.
Step 5
- Reconnect to main motherboard.
Reconnect to main motherboard.
Step 6
- reassemble.
- Enjoy the new display
reassemble.
Enjoy the new display
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 2 other contributors
jckoniecki
Member since: 11/08/2010
51 Reputation
1 Guide authored
Badges:
3
