Difficulty
Easy
Steps
7
Time Required
30 minutes
Sections
2
- Back Panel
- 2 steps
- Speaker
- 5 steps
Flags
1
Member-Contributed Guide
An awesome member of our community made this guide. It is not managed by iFixit staff.
BackSharper Image SBT5002
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Back Panel
- Unplug the speaker before doing any work on it.
- Use a #0 Phillips screwdriver to remove the eight 13mm Phillips head screws from the back panel.
Unplug the speaker before doing any work on it.
Use a #0 Phillips screwdriver to remove the eight 13mm Phillips head screws from the back panel.
1024
Step 2
- Remove the back panel.
Remove the back panel.
Step 3
Speaker
- Remove the snap cable that connects the speaker to the circuit board.
Remove the snap cable that connects the speaker to the circuit board.
Step 4
- Use a tap hammer and a punch to release the 4 posts that hold the front panel in place.
Use a tap hammer and a punch to release the 4 posts that hold the front panel in place.
Step 5
- Use a plastic opening tool or spudger to pry off the front panel.
Use a plastic opening tool or spudger to pry off the front panel.
Step 6
- Use a#4 Phillips screwdriver to remove the four 9.5mm screws that secure the subwoofer to the woofer box.
Use a#4 Phillips screwdriver to remove the four 9.5mm screws that secure the subwoofer to the woofer box.
Step 7
- Remove the defective speaker.
Remove the defective speaker.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Linda Freund
Member since: 08/06/2017
235 Reputation
2 Guides authored
Badges:
10
+7 more badges
