Siriusxm Onyx Plus Motherboard Replacement Repair Guide

Difficulty

Moderate

Steps

9

Time Required

                          7 minutes            

Sections

2

• Case
• 3 steps
• Motherboard
• 6 steps

Flags

0

• BackSirius XM Onyx Plus

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Case               

• Wedge a plastic opening tool in between the case.

Wedge a plastic opening tool in between the case.

1024

Step 2

• Starting with the bottom left corner, press down on the plastic opening tool to unhook the latches on the inside of the device.
• You have to start with the bottom left and right corners, and then flip the device to over and do the top of the device.

Starting with the bottom left corner, press down on the plastic opening tool to unhook the latches on the inside of the device.

You have to start with the bottom left and right corners, and then flip the device to over and do the top of the device.

Step 3

• Once unclipped, separate the back casing from the device.

Once unclipped, separate the back casing from the device.

Step 4

              Motherboard               

• Remove the three 5.4mm JIS #00 screws from the motherboard.

Remove the three 5.4mm JIS #00 screws from the motherboard.

Step 5

• Unlatch the two clips located at the top of the device that hold the motherboard in place.

Unlatch the two clips located at the top of the device that hold the motherboard in place.

Step 6

• Lift the motherboard up from the bottom.

Lift the motherboard up from the bottom.

Step 7

• Lift the screen up, so you can see where it is attached to the motherboard.

Lift the screen up, so you can see where it is attached to the motherboard.

Step 8

• Use a spudger to flip up the retaining flap on the display ribbon cable ZIF socket.

Use a spudger to flip up the retaining flap on the display ribbon cable ZIF socket.

Step 9

• Carefully pull the ribbon out from the ZIF connector.

Carefully pull the ribbon out from the ZIF connector.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    Angel Rivera                     

Member since: 01/25/2018

532 Reputation

                                      5 Guides authored                  



                       Badges:
                       6







                                                        +3 more badges                           

Team

                       USF Tampa, Team S7-G2, Passmore Spring 2018                        

                                                  Member of USF Tampa, Team S7-G2, Passmore Spring 2018 



                    USFT-PASSMORE-S18S7G2                     


                                            4 Members                     


                                            5 Guides authored