Skil 88 Motor Housing Replacement Repair Guide

Difficulty

Moderate

Steps

8

Time Required

                          10 minutes            

Sections

3

• Disassembling Skil 88 Front Housing
• 2 steps
• Trigger Housing
• 2 steps
• Motor Housing
• 4 steps

Flags

1

Missed a Step

Oops! This guide is currently missing some important steps.

• BackSkil 88

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              Disassembling Skil 88 Front Housing               

• On the front of the drill, remove the three 2" flathead screws connecting the front housing to the rear housing.

On the front of the drill, remove the three 2" flathead screws connecting the front housing to the rear housing.

1024

Step 2

• Pull the front housing apart from the rear.
• The motor and gears might fall out when you are pulling it apart.

Pull the front housing apart from the rear.

The motor and gears might fall out when you are pulling it apart.

Step 3

              Trigger Housing               

• Use the socket wrench to remove the 0.5" length screw from the bottom of the handle.

Use the socket wrench to remove the 0.5" length screw from the bottom of the handle.

Step 4

• Separate the cord from the handle.

Separate the cord from the handle.

Step 5

              Motor Housing               

• Remove the inner divider.

Remove the inner divider.

Step 6

• Remove the two 1" flathead screws located at the top and bottom of the motor housing.

Remove the two 1" flathead screws located at the top and bottom of the motor housing.

Step 7

• Pull the motor housing out.
• The wires from the trigger housing should follow the motor housing.

Pull the motor housing out.

The wires from the trigger housing should follow the motor housing.

Step 8

• After you have placed the motor housing back into the drill during reassembly, thread the wires down to the handle using tweezers.
• Plug the forked wire into the socket at the back of the motor housing using tweezers.

After you have placed the motor housing back into the drill during reassembly, thread the wires down to the handle using tweezers.

Plug the forked wire into the socket at the back of the motor housing using tweezers.

To continue reassembly, simply follow the guide backwards starting at step 2.

Cancel: I did not complete this guide.

Author

                                      with 4 other contributors 

                    Matt                     

Member since: 10/10/2010

365 Reputation

                                      7 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges                           

Team

                       Cal Poly, Team 5-17, Maness Fall 2010                        

                                                  Member of Cal Poly, Team 5-17, Maness Fall 2010 



                    CPSU-MANESS-F10S5G17                     


                                            3 Members                     


                                            7 Guides authored