Difficulty
Easy
Steps
4
Time Required
2 - 5 minutes
Sections
2
- Trigger Housing
- 2 steps
- Trigger Mechanism
- 2 steps
Flags
1
Missed a Step
Oops! This guide is currently missing some important steps.
BackSkil 88
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Trigger Housing
- Use the socket wrench to remove the 0.5" length screw from the bottom of the handle.
Use the socket wrench to remove the 0.5" length screw from the bottom of the handle.
1024
Step 2
- Separate the cord from the handle.
Separate the cord from the handle.
Step 3
Trigger Mechanism
- Make sure that the drill is completely unplugged.
- Locate the two wires attached to the black trigger.
- Pull the wires out of the trigger. It may take a bit of force.
Make sure that the drill is completely unplugged.
Locate the two wires attached to the black trigger.
Pull the wires out of the trigger. It may take a bit of force.
Step 4
- Push the wires into the new trigger piece.
- Make sure the wires go back into the correct holes.
Push the wires into the new trigger piece.
Make sure the wires go back into the correct holes.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 3 other contributors
Matt
Member since: 10/10/2010
365 Reputation
7 Guides authored
Badges:
8
+5 more badges
Team
Cal Poly, Team 5-17, Maness Fall 2010
Member of Cal Poly, Team 5-17, Maness Fall 2010
CPSU-MANESS-F10S5G17
3 Members
7 Guides authored
