Difficulty

Moderate

Steps

5

Time Required

                          1 - 3 minutes

Sections

3

  • Battery
  • 2 steps
  • Handle
  • 1 step
  • Chuck Sleeve
  • 2 steps

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackSkil X-Drive 18V Cordless Drill Model No. 2887

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Un-clip Battery
  • Grip the drill. Locate the red locking switch on the back of the battery. Hold the switch down.

Grip the drill. Locate the red locking switch on the back of the battery. Hold the switch down.

1024

Step 2

              Remove Battery
  • While holding down the red locking switch, slide the battery towards the back of the drill until the battery is fully removed from the drill.

While holding down the red locking switch, slide the battery towards the back of the drill until the battery is fully removed from the drill.

Step 3

              Remove Handle
  • Grip cordless drill firmly with left hand. Grip the cordless drill handle firmly with the right hand. Rotate the handle counterclockwise in order to remove the handle from the drill.

Grip cordless drill firmly with left hand. Grip the cordless drill handle firmly with the right hand. Rotate the handle counterclockwise in order to remove the handle from the drill.

Step 4

              Remove the screw from the chuck sleeve
  • The chuck sleeve is held on by a 20mm Phillips #2 screw in the center.This screw is reverse threaded. Insert a Phillips #2 screwdriver and rotate it clockwise to loosen and remove it.

The chuck sleeve is held on by a 20mm Phillips #2 screw in the center.This screw is reverse threaded. Insert a Phillips #2 screwdriver and rotate it clockwise to loosen and remove it.

Step 5

              Remove the chuck sleeve
  • The threaded hole the screw was in is in the shape of a 6-point star. Insert a T40 Torx Key and rotate it clockwise to loosen and remove the chuck sleeve.

The threaded hole the screw was in is in the shape of a 6-point star. Insert a T40 Torx Key and rotate it clockwise to loosen and remove the chuck sleeve.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 


                    Jameson

Member since: 09/23/2014

258 Reputation

                                      2 Guides authored                  



                       Badges:
                       8







                                                        +5 more badges

Team

                       USF Tampa, Team 2-3, Blackwell Fall 2014                        

                                                  Member of USF Tampa, Team 2-3, Blackwell Fall 2014 



                    USFT-BLACKWELL-F14S2G3                     


                                            5 Members                     


                                            9 Guides authored

Joe Bailey - Jun 19, 2016

Reply

For my drill, the Torx screw had to be rotated *counter-clockwise to remove. I’m not sure if that was an error in step #5 or some drills are different.

Thank you for the location of those screws btw.

“Step 5 — Remove the chuck sleeve

The threaded hole the screw was in is in the

shape of a 6-point star. Insert a T40 Torx Key

and rotate it *clockwise to loosen and remove

the chuck sleeve.”