Skullcandy Crusher Wireless Headphone Usb Connector Replacement Repair Guide

Difficulty

Difficult

Steps

7

Time Required

                          30 - 50 minutes            

Sections

2

• Ear Cushion
• 3 steps
• USB Connector
• 4 steps

Flags

0

• BackSkullcandy Crusher Wireless

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Follow this guide if the USB connector has been damaged or is malfunctioning (or maybe you just want to see the internal components of your Skullcandy Crusher Wireless).

Also, for more information about soldering and desoldering, please use this guide.

What you need

Step 1

              Ear Cushion               

• Take your headphones and hold them upside down for better control with your hands.

Take your headphones and hold them upside down for better control with your hands.

1024

Step 2

• Grab the ear cushion firmly between your thumb and forefinger with a tight grip.
• Pull the ear cushion away from the plastic, covering the speaker, by sliding the ear cushion down to release it.

Grab the ear cushion firmly between your thumb and forefinger with a tight grip.

Pull the ear cushion away from the plastic, covering the speaker, by sliding the ear cushion down to release it.

Step 3

• Continue pulling it away from the edges of the plastic covering until the cushion is fully removed.

Continue pulling it away from the edges of the plastic covering until the cushion is fully removed.

Step 4

              USB Connector               

• Remove three 12 mm Phillips #1 screws located underneath the left ear cushion.

Remove three 12 mm Phillips #1 screws located underneath the left ear cushion.

Step 5

• Slide a plastic opening tool between the plastic frame and speaker assembly of the headphones.
• Gently pry the speaker away from the frame of the headphones.

Slide a plastic opening tool between the plastic frame and speaker assembly of the headphones.

Gently pry the speaker away from the frame of the headphones.

Step 6

• Separate the headphone speaker assembly from headphone speaker frame.

Separate the headphone speaker assembly from headphone speaker frame.

Step 7

• Inspect the USB port and ensure that it is connected correctly. If necessary, desolder the USB port and replace it with the new port.
• For more information on soldering, please, use this Solder and Desolder Connections guide.

Inspect the USB port and ensure that it is connected correctly. If necessary, desolder the USB port and replace it with the new port.

For more information on soldering, please, use this Solder and Desolder Connections guide.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 

                    Val                     

Member since: 03/31/2022

876 Reputation

                                      6 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       UMass Dartmouth, Team 1-33, Gurgel Spring 2022                        

                                                  Member of UMass Dartmouth, Team 1-33, Gurgel Spring 2022 



                    UMASSD-GURGEL-S22S1G33                     


                                            1 Member                     


                                            12 Guides authored