Difficulty

Moderate

Steps

6

Time Required

                          15 minutes

Sections

1

  • Size Adjuster
  • 6 steps

Flags

2

Needs More Images

A few more images would make this guide’s procedures crystal clear.

Missed a Step

Oops! This guide is currently missing some important steps.

  • BackSkullCandy Hesh

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Determine the damage
  • Locate the break in the device.

Locate the break in the device.

1024

Step 2

  • Use a Phillips #0 screwdriver to remove the two 9 mm screws from the bottom inner casing beneath the break.

Use a Phillips #0 screwdriver to remove the two 9 mm screws from the bottom inner casing beneath the break.

Step 3

  • Remove the bottom inner casing to reveal the wire compartment and the port where the slider inserts.

Remove the bottom inner casing to reveal the wire compartment and the port where the slider inserts.

Step 4

  • Cover the detached slider port in a generous layer of Plasti Dip, which works like glue. Also coat any exposed wire to seal the circuit.

Cover the detached slider port in a generous layer of Plasti Dip, which works like glue. Also coat any exposed wire to seal the circuit.

Step 5

  • Realign the broken size adjuster into the port with the Plasti Dip so that it can be secured to the ear piece.

Realign the broken size adjuster into the port with the Plasti Dip so that it can be secured to the ear piece.

Step 6

  • Clamp the pieces in place by hand or with a binder clip until the Plasti Dip dries. Feel free to use a hair dryer on a low setting to speed up the process.

Clamp the pieces in place by hand or with a binder clip until the Plasti Dip dries. Feel free to use a hair dryer on a low setting to speed up the process.

To reassemble your device, reattach the bottom inner casing with the Phillips #0 screwdriver and two removed screws.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 


                    Sarah Burk

Member since: 01/15/2015

247 Reputation

                                      3 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       USF Sarasota-Manatee, Team 1-1, Stewart Winter 2015                        

                                                  Member of USF Sarasota-Manatee, Team 1-1, Stewart Winter 2015 



                    USFSM-STEWART-W15S1G1                     


                                            4 Members                     


                                            10 Guides authored