Difficulty
Moderate
Steps
7
Time Required
Suggest a time??
Sections
4
- Rotor Blade
- 1 step
- Lockstitch
- 1 step
- Lower and Upper Body
- 2 steps
- Gear
- 3 steps
Flags
1
Better Introduction
Improve this guide by completing or revising its introduction.
BackSky Thunder HD 8500WH
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
What you need
Step 1
Rotor Blade
- Place the drone with the top side facing up.
- Remove the blade cover.
- Remove the rotor blade.
Place the drone with the top side facing up.
Remove the blade cover.
Remove the rotor blade.
1024
Step 2
Lockstitch
- Unscrew the 1cm screw holding in the blade lockstitch with the Phillips 0 Screwdriver.
- Remove the blade lockstitch.
Unscrew the 1cm screw holding in the blade lockstitch with the Phillips 0 Screwdriver.
Remove the blade lockstitch.
Step 3
Lower and Upper Body
- Lay down the drone so the battery side is facing up.
- Unscrew all 5 .8cm screws on each arm of the drone with the Phillips 0 Screwdriver.
- Repeat previous bullet for each arm (20 screws in total).
Lay down the drone so the battery side is facing up.
Unscrew all 5 .8cm screws on each arm of the drone with the Phillips 0 Screwdriver.
Repeat previous bullet for each arm (20 screws in total).
Step 4
- Using a bit of force, gently pull apart the lower and upper bodies.
- Keep going until both parts are completely separated.
Using a bit of force, gently pull apart the lower and upper bodies.
Keep going until both parts are completely separated.
Step 5
Gear
- Find the gear mechanism at the end of one of the drone arms.
- Unscrew the two front .8cm screws with the Phillips 0 Screwdriver.
Find the gear mechanism at the end of one of the drone arms.
Unscrew the two front .8cm screws with the Phillips 0 Screwdriver.
Step 6
- Remove the white spacer.
- Remove the red spacer.
Remove the white spacer.
Remove the red spacer.
Step 7
- Pull the gear out from the bottom of the holding mechanism.
Pull the gear out from the bottom of the holding mechanism.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 3 other contributors
Nicholas Jones
Member since: 09/25/2017
648 Reputation
5 Guides authored
Badges:
7
+4 more badges
Team
University of North Texas, Team S2-G7, Thompson Fall 2017
Member of University of North Texas, Team S2-G7, Thompson Fall 2017
UNT-THOMPSON-F17S2G7
3 Members
5 Guides authored
