Difficulty

Difficult

Steps

8

Time Required

Suggest a time??

Sections

5

  • Rotor Blade
  • 1 step
  • Lockstitch
  • 1 step
  • Lower and Upper Body
  • 2 steps
  • Gear
  • 3 steps
  • Motor
  • 1 step

Flags

1

Better Introduction

Improve this guide by completing or revising its introduction.

  • BackSky Thunder HD 8500WH

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

What you need

Step 1

              Rotor Blade
  • Place the drone with the top side facing up.
  • Remove the blade cover.
  • Remove the rotor blade.

Place the drone with the top side facing up.

Remove the blade cover.

Remove the rotor blade.

1024

Step 2

              Lockstitch
  • Unscrew the 1cm screw holding in the blade lockstitch with the Phillips 0 Screwdriver.
  • Remove the blade lockstitch.

Unscrew the 1cm screw holding in the blade lockstitch with the Phillips 0 Screwdriver.

Remove the blade lockstitch.

Step 3

              Lower and Upper Body
  • Lay down the drone so the battery side is facing up.
  • Unscrew all 5 .8cm screws on each arm of the drone with the Phillips 0 Screwdriver.
  • Repeat previous bullet for each arm (20 screws in total).

Lay down the drone so the battery side is facing up.

Unscrew all 5 .8cm screws on each arm of the drone with the Phillips 0 Screwdriver.

Repeat previous bullet for each arm (20 screws in total).

Step 4

  • Using a bit of force, gently pull apart the lower and upper bodies.
  • Keep going until both parts are completely separated.

Using a bit of force, gently pull apart the lower and upper bodies.

Keep going until both parts are completely separated.

Step 5

              Gear
  • Find the gear mechanism at the end of one of the drone arms.
  • Unscrew the two front .8cm screws with the Phillips 0 Screwdriver.

Find the gear mechanism at the end of one of the drone arms.

Unscrew the two front .8cm screws with the Phillips 0 Screwdriver.

Step 6

  • Remove the white spacer.
  • Remove the red spacer.

Remove the white spacer.

Remove the red spacer.

Step 7

  • Pull the gear out from the bottom of the holding mechanism.

Pull the gear out from the bottom of the holding mechanism.

Step 8

              Motor
  • Unscrew the two .8cm screws on the bottom of the holding mechanism with the Phillips 0 Screwdriver.
  • Remove the motor from the holding mechanism.

Unscrew the two .8cm screws on the bottom of the holding mechanism with the Phillips 0 Screwdriver.

Remove the motor from the holding mechanism.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      2 other people completed this guide.

Author

                                      with 1 other contributor 


                    Nicholas Jones

Member since: 09/25/2017

648 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges

Team

                       University of North Texas, Team S2-G7, Thompson Fall 2017                        

                                                  Member of University of North Texas, Team S2-G7, Thompson Fall 2017 



                    UNT-THOMPSON-F17S2G7                     


                                            3 Members                     


                                            5 Guides authored