Solio Rocsta Charging Cable Replacement Repair Guide

Difficulty

Difficult

Steps

6

Time Required

                          10 - 25 minutes            

Sections

1

• Charging Cable
• 6 steps

Flags

0

• BackSolio Rocsta Replacement

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

Please note that this guide requires soldering. For more information on how to solder and desolder connections, please visit this guide.

What you need

Step 1

              Charging Cable               

• Locate, and unscrew, the three 5.72 mm screws that hold down the top cover using the T6 Torx screwdriver.

Locate, and unscrew, the three 5.72 mm screws that hold down the top cover using the T6 Torx screwdriver.

1024

Step 2

• Remove top cover.
• Caution: the solar cell is attached to the top cover and connected to the circuit board by a short wire.

Remove top cover.

Caution: the solar cell is attached to the top cover and connected to the circuit board by a short wire.

Step 3

• Using the spudger, pry the battery off the back cover.

Using the spudger, pry the battery off the back cover.

Step 4

• Unscrew the 5.66 mm screws attaching the circuit board to the case.

Unscrew the 5.66 mm screws attaching the circuit board to the case.

Step 5

• With the circuit board flipped, locate the battery connector.
• Hold the component attached to the circuit board the battery is connected to and wiggle the cable out.

With the circuit board flipped, locate the battery connector.

Hold the component attached to the circuit board the battery is connected to and wiggle the cable out.

Step 6

• With a Soldering Iron, desolder the four cables that connect the charging cable to the circuit board.
• The power cable is a series of four cables. Make note of each cable placement for easy resoldering.
• For more information on how to solder and desolder connections, please visit this guide.

With a Soldering Iron, desolder the four cables that connect the charging cable to the circuit board.

The power cable is a series of four cables. Make note of each cable placement for easy resoldering.

For more information on how to solder and desolder connections, please visit this guide.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 2 other contributors 

                    David Vazquez                     

Member since: 10/10/2017

577 Reputation

                                      5 Guides authored                  



                       Badges:
                       7







                                                        +4 more badges                           

Team

                       USF Tampa, Team S13-G13, Cagle Fall 2017                        

                                                  Member of USF Tampa, Team S13-G13, Cagle Fall 2017 



                    USFT-CAGLE-F17S13G13                     


                                            4 Members                     


                                            6 Guides authored