Difficulty
Moderate
Steps
5
Time Required
15 - 45 minutes
Sections
1
- Power Port
- 5 steps
Flags
0
BackSonos Bridge
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Power Port
- The rubber bottom is glued on, meaning it can be easily pried off using the metal spudger.
- You may have to pry from multiple locations.
The rubber bottom is glued on, meaning it can be easily pried off using the metal spudger.
You may have to pry from multiple locations.
1024
Step 2
- There is one screw in each corner of the base for a total of four screws.
- Remove each screw using the Phillips 1 screwdriver.
- The four screws are each 0.9 cm long.
- The screws are small, so be careful to not lose them.
There is one screw in each corner of the base for a total of four screws.
Remove each screw using the Phillips 1 screwdriver.
The four screws are each 0.9 cm long.
The screws are small, so be careful to not lose them.
Step 3
- Use the metal spudger to pry out the plastic bottom.
- Alternatively, the casing can be lightly tapped on a table (base down) to drop the bottom out of the casing.
Use the metal spudger to pry out the plastic bottom.
Alternatively, the casing can be lightly tapped on a table (base down) to drop the bottom out of the casing.
Step 4
- Pry out the circuit board.
- Place the metal spudger under the board on the side opposite the two ports.
- The board can then be easily wiggled out of the casing.
- This should NOT require significant force.
Pry out the circuit board.
Place the metal spudger under the board on the side opposite the two ports.
The board can then be easily wiggled out of the casing.
This should NOT require significant force.
Step 5
- Locate the Power port on the circuit board, shown with the red box in the first image.
- Locate the solders attached to the Power port.
- Use the soldering iron to undo the solders.
Locate the Power port on the circuit board, shown with the red box in the first image.
Locate the solders attached to the Power port.
Use the soldering iron to undo the solders.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Brian Strader
Member since: 11/07/2017
201 Reputation
2 Guides authored
Badges:
4
+1 more badge
Team
IUPUI, Team S3-G4, Harley Fall 2017
Member of IUPUI, Team S3-G4, Harley Fall 2017
IUPUI-HARLEY-F17S3G4
3 Members
2 Guides authored
