Difficulty

Moderate

Steps

9

Time Required

                          3 minutes

Sections

2

  • Protective Cover
  • 5 steps
  • Control Panel & Microphone
  • 4 steps

Flags

0

  • BackSonos One

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Protective Cover
  • Disconnect all power cords.
  • Remove the rubber foot and plastic screw guard on the bottom of the device using a plastic opening tool.
  • Note: the rubber foot and plastic screw guard can be removed as one piece to make reassembly easier

Disconnect all power cords.

Remove the rubber foot and plastic screw guard on the bottom of the device using a plastic opening tool.

Note: the rubber foot and plastic screw guard can be removed as one piece to make reassembly easier

1024

Step 2

  • Remove the four 10mm Torx T10 screws from the bottom of the speaker.

Remove the four 10mm Torx T10 screws from the bottom of the speaker.

Step 3

  • Remove the bottom cover by squeezing the protective cover slightly while pushing up with your fingers.

Remove the bottom cover by squeezing the protective cover slightly while pushing up with your fingers.

Step 4

  • The protective cover clip is very thin and deforms easily.
  • Remove the single 8mm Torx T10 screw and protective cover clip.

The protective cover clip is very thin and deforms easily.

Remove the single 8mm Torx T10 screw and protective cover clip.

Step 5

  • Slide the protective cover upwards to remove.

Slide the protective cover upwards to remove.

Step 6

              Control Panel & Microphone
  • Use the pointed end of a spudger to remove the covers that hide the screws.
  • Remove the four 9mm Torx T8 screws from around the perimeter of the control panel.

Use the pointed end of a spudger to remove the covers that hide the screws.

Remove the four 9mm Torx T8 screws from around the perimeter of the control panel.

Step 7

  • With the front of the unit facing you, lift the control panel up using your thumbs.
  • There’s a ribbon cable attaching the control panel to the speaker so work slowly.

With the front of the unit facing you, lift the control panel up using your thumbs.

There’s a ribbon cable attaching the control panel to the speaker so work slowly.

Step 8

  • Use a spudger to flip up the retaining flap on the control panel ribbon cable ZIF socket.
  • Pull the control panel ribbon cable out of its socket.

Use a spudger to flip up the retaining flap on the control panel ribbon cable ZIF socket.

Pull the control panel ribbon cable out of its socket.

Step 9

  • Pull the control panel away from the speaker to separate.

Pull the control panel away from the speaker to separate.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      One other person completed this guide.

Author

                                      with 2 other contributors 


                    Marcus Glowa

Member since: 02/14/2018

785 Reputation

                                      5 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       USF Tampa, Team S2-G1, Nance Spring 2018                        

                                                  Member of USF Tampa, Team S2-G1, Nance Spring 2018 



                    USFT-NANCE-S18S2G1                     


                                            3 Members                     


                                            5 Guides authored

Chris Myers - Jul 31, 2022

Reply

where can I buy a replacement control panel?