Difficulty
Easy
Steps
3
Time Required
5 minutes
Sections
1
- Lens Mount
- 3 steps
Flags
0
BackSony α6500
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Lens Mount
- Use a screwdriver to remove four 5mm JIS 00 screws from the lens mount.
Use a screwdriver to remove four 5mm JIS 00 screws from the lens mount.
1024
Step 2
- Pull the lens mount off by gently wiggling it until it comes loose.
- It is difficult to slide the mount off the metal pin sticking through the lower left side. Pull it off from where the pin is if it gets stuck.
Pull the lens mount off by gently wiggling it until it comes loose.
It is difficult to slide the mount off the metal pin sticking through the lower left side. Pull it off from where the pin is if it gets stuck.
Step 3
- Remove the metal ring underneath the lens mount.
- When replacing the ring, line up the two holes in the ring with the two pins on either side of the mount.
Remove the metal ring underneath the lens mount.
When replacing the ring, line up the two holes in the ring with the two pins on either side of the mount.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Author
with 5 other contributors
Jackson Furie
Member since: 10/10/2019
735 Reputation
5 Guides authored
Badges:
14
+11 more badges
Team
Cal Poly, Team S11-G5, Regan Fall 2019
Member of Cal Poly, Team S11-G5, Regan Fall 2019
CPSU-REGAN-F19S11G5
5 Members
14 Guides authored
