Difficulty

Moderate

Steps

10

Time Required

                          10 minutes

Sections

2

  • Rear Case
  • 3 steps
  • Motherboard
  • 7 steps

Flags

0

  • BackSony Alpha A3000

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              Rear Case
  • Remove the seven highlighted screws shown here.
  • Screws are teeny tiny, don’t lose them!

Remove the seven highlighted screws shown here.

Screws are teeny tiny, don’t lose them!

1024

Step 2

  • Remove this final screw from the memory card compartment.
  • Remove the chassis by pulling the back cover away from the camera.
  • Be careful not to damage any of the delicate ribbon cables when removing the chassis.

Remove this final screw from the memory card compartment.

Remove the chassis by pulling the back cover away from the camera.

Be careful not to damage any of the delicate ribbon cables when removing the chassis.

Step 3

  • Gently but forcefully lift up on the parallel cable connecting the two halves of the camera.

Gently but forcefully lift up on the parallel cable connecting the two halves of the camera.

Step 4

              Motherboard
  • After removing the backing from the camera. Remove the two final screws in the memory compartment area.
  • Detach the facing for the memory dock.

After removing the backing from the camera. Remove the two final screws in the memory compartment area.

Detach the facing for the memory dock.

Step 5

  • Remove the eight screws securing the mount for the flash device.

Remove the eight screws securing the mount for the flash device.

Step 6

  • Remove the three remaining screws holding in the protective metal casing.

Remove the three remaining screws holding in the protective metal casing.

Step 7

  • Remove the metal casing.

Remove the metal casing.

Step 8

  • Remove three screws holding down the motherboard .

Remove three screws holding down the motherboard .

Step 9

  • Detach the nine serial cables connecting it to the camera body.

Detach the nine serial cables connecting it to the camera body.

Step 10

  • Finally remove the motherboard from the casing.

Finally remove the motherboard from the casing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

                                                                                      5 other people completed this guide.

Author

                                      with 4 other contributors 


                    Leonard Holloman

Member since: 08/31/2015

626 Reputation

                                      4 Guides authored                  



                       Badges:
                       12







                                                        +9 more badges

Team

                       USF Tampa, Team 4-4, Meier Fall 2015                        

                                                  Member of USF Tampa, Team 4-4, Meier Fall 2015 



                    USFT-MEIER-F15S4G4                     


                                            4 Members                     


                                            10 Guides authored

kongre172 - May 6, 2017

Reply

Then loose the plug all the motherboard?