Difficulty

Easy

Steps

6

Time Required

                          5 - 10 minutes

Sections

2

  • Front Panel
  • 3 steps
  • Disk Drive
  • 3 steps

Flags

0

  • BackSony BDP-S3500

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

Be sure to review the troubleshooting guide, as most of the time the problems are due to malfunctioning software rather than it being a hardware issue.

This guide will show you how to safely disassemble the device by removing the required parts and connections so that the disk drive can be replaced without damaging any of the other components.

What you need

Step 1

              Front Panel
  • Use the Phillips #2 screwdriver to remove the two 9mm screws located on the back of the device.

Use the Phillips #2 screwdriver to remove the two 9mm screws located on the back of the device.

1024

Step 2

  • Slide the top panel off towards the back of the device.
  • Remove the top panel.

Slide the top panel off towards the back of the device.

Remove the top panel.

Step 3

  • Unclip the plastic tags from the bottom of the device.
  • Unclip the plastic tags from the sides of the device.
  • Slide the front panel off.

Unclip the plastic tags from the bottom of the device.

Unclip the plastic tags from the sides of the device.

Slide the front panel off.

Step 4

              Disk Drive
  • Remove the three ribbon cables by gently pulling the cables out of each connector.
  • Be sure to only handle the circuit board from the edges so that the PCB is not damaged.

Remove the three ribbon cables by gently pulling the cables out of each connector.

Be sure to only handle the circuit board from the edges so that the PCB is not damaged.

Step 5

  • Use a Phillips #2 screwdriver to remove the two 9mm screws that are holding the disk drive in place.

Use a Phillips #2 screwdriver to remove the two 9mm screws that are holding the disk drive in place.

Step 6

  • Carefully lift and slide the disk drive out of the casing.

Carefully lift and slide the disk drive out of the casing.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    V W

Member since: 01/22/2020

197 Reputation

                                      1 Guide authored                  



                       Badges:
                       4







                                                        +1 more badge

Team

                       York University, Team S8-G4, Turner Winter 2020                        

                                                  Member of York University, Team S8-G4, Turner Winter 2020 



                    YORK-TURNER-W20S8G4                     


                                            4 Members                     


                                            5 Guides authored