Difficulty

Moderate

Steps

6

Time Required

                          5 - 6 minutes

Sections

2

  • Front Panel
  • 3 steps
  • Port Board
  • 3 steps

Flags

1

Inconsistent Images

Updating the images on this guide to be more consistent with the prerequisites would increase its awesomeness.

  • BackSony BDP-S3500

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

If the USB port contains dust, then it might not work properly. Please clean it using an air blower.

If you think the IR sensor is not working, please check that the remote is completely working and that there is no obstruction blocking the sensor on either the remote or the Blu-ray player.

Please be gentle during the process as some parts are delicate to handle.

Before using this guide, make sure to review the troubleshooting page.

What you need

Step 1

              Front Panel
  • Use the Phillips #2 screwdriver to remove the two 9mm screws located on the back of the device.

Use the Phillips #2 screwdriver to remove the two 9mm screws located on the back of the device.

1024

Step 2

  • Slide the top panel off towards the back of the device.
  • Remove the top panel.

Slide the top panel off towards the back of the device.

Remove the top panel.

Step 3

  • Unclip the plastic tags from the bottom of the device.
  • Unclip the plastic tags from the sides of the device.
  • Slide the front panel off.

Unclip the plastic tags from the bottom of the device.

Unclip the plastic tags from the sides of the device.

Slide the front panel off.

Step 4

              Port Board
  • Keep the back side up and facing towards you.
  • Carefully disconnect the blue ribbon connecting the port board and motherboard.
  • Be delicate while removing the ribbon.

Keep the back side up and facing towards you.

Carefully disconnect the blue ribbon connecting the port board and motherboard.

Be delicate while removing the ribbon.

Step 5

  • Use a Phillips #2 screwdriver to remove the 9mm screw from the port board.

Use a Phillips #2 screwdriver to remove the 9mm screw from the port board.

Step 6

  • Remove the port board from the device.

Remove the port board from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 1 other contributor 


                    Megh Ladumor

Member since: 01/22/2020

100 Reputation

                                      1 Guide authored                  



                       Badges:
                       5







                                                        +2 more badges

Team

                       York University, Team S8-G4, Turner Winter 2020                        

                                                  Member of York University, Team S8-G4, Turner Winter 2020 



                    YORK-TURNER-W20S8G4                     


                                            4 Members                     


                                            5 Guides authored