Sony Betamovie Bmc 220 Power Button Replacement Repair Guide

Difficulty

Moderate

Steps

Time Required

                          9 - 10 minutes

Sections

Battery
3 steps
Power Button
3 steps

Flags

BackSony Betamovie BMC-220
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications

Introduction

What you need

Step 1

              Battery

Orient your Betamovie so that the back of the device is sitting flat, and the bottom of the device is facing you.
Slide the RELEASE switch up to bring the hand drip down.

Orient your Betamovie so that the back of the device is sitting flat, and the bottom of the device is facing you.

Slide the RELEASE switch up to bring the hand drip down.

1024

Step 2

Turn the BATTERY knob to OPEN, and open the lid.
Reminder: When inserting a new battery, make sure the knob is turned to OPEN.
Be careful not to point the hand grip down when turning the BATTERY knob. The battery pack may fall out.

Turn the BATTERY knob to OPEN, and open the lid.

Reminder: When inserting a new battery, make sure the knob is turned to OPEN.

Be careful not to point the hand grip down when turning the BATTERY knob. The battery pack may fall out.

Step 3

Remove the battery from the Betamovie.

Remove the battery from the Betamovie.

Step 4

              Power Button

Remove the two screws (2mm x 6mm) on either side of the FILTER switch on the black and white side of the Betamovie using the Phillips #0 screwdriver.
Remove the two screws on the bottom of the camera on the side with the black and white face using the same screwdriver.
Remove the screws on the bottom of the back of the camera with the same screwdriver.

Remove the two screws (2mm x 6mm) on either side of the FILTER switch on the black and white side of the Betamovie using the Phillips #0 screwdriver.

Remove the two screws on the bottom of the camera on the side with the black and white face using the same screwdriver.

Remove the screws on the bottom of the back of the camera with the same screwdriver.

Step 5

Remove the silver rectangular piece at the top of the Betamovie using your hands.
Remove the two screws (2mm x 6mm) under the flat silver piece using the Phillips #1 screwdriver. The silver metal clip comes off once the crews are removed.

Remove the silver rectangular piece at the top of the Betamovie using your hands.

Remove the two screws (2mm x 6mm) under the flat silver piece using the Phillips #1 screwdriver. The silver metal clip comes off once the crews are removed.

Step 6

Remove the black and white cover from the Betamovie.
Remove the power button from the black and white face.

Remove the black and white cover from the Betamovie.

Remove the power button from the black and white face.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 3 other contributors

                    Jordan Bates

Member since: 09/10/2018

315 Reputation

                                      3 Guides authored                  



                       Badges:
                       3

Team

                       University of Alabama, Team S2-G5, Bedsole Fall 2018                        

                                                  Member of University of Alabama, Team S2-G5, Bedsole Fall 2018 



                    UA-BEDSOLE-F18S2G5                     


                                            3 Members                     


                                            8 Guides authored

Introduction#

What you need#

Team#

Introduction

What you need

Team