Difficulty
Easy
Steps
6
Time Required
5 - 10 minutes
Sections
2
- Wiring Harness
- 2 steps
- Back Panel
- 4 steps
Flags
0
BackSony CDX-GT540UI
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
Before any repair work can be done one must remove the device for the vehicle. To do so follow this link to see a general vehicle removal of a stereo system.
What you need
Step 1
Wiring Harness
- Locate the clip on the wiring harness.
Locate the clip on the wiring harness.
1024
Step 2
- Press down on the clip like you would an Ethernet cable.
- Rock harness side to side, pulling gently towards you until harness detaches.
Press down on the clip like you would an Ethernet cable.
Rock harness side to side, pulling gently towards you until harness detaches.
Step 3
Back Panel
- Locate back panel.
Locate back panel.
Step 4
- Remove four 11.5mm Phillips #00 (silver) screws from back panel.
Remove four 11.5mm Phillips #00 (silver) screws from back panel.
Step 5
- Remove four 9.5mm Phillips #00 (black) screws from back panel.
- Remove two 7.5mm Phillips #00 (black) screws from back panel.
Remove four 9.5mm Phillips #00 (black) screws from back panel.
Remove two 7.5mm Phillips #00 (black) screws from back panel.
Step 6
- Remove back panel.
- On the back panel there will be thermal (white) paste. Do not touch.
Remove back panel.
On the back panel there will be thermal (white) paste. Do not touch.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
2 other people completed this guide.
Author
with 4 other contributors
Odelkys Marquez
Member since: 09/22/2014
1,067 Reputation
7 Guides authored
Badges:
14
+11 more badges
Team
USF Tampa, Team 10-2, Brown Fall 2014
Member of USF Tampa, Team 10-2, Brown Fall 2014
USFT-BROWN-F14S10G2
3 Members
7 Guides authored