Difficulty
Moderate
Steps
7
Time Required
30 - 45 minutes
Sections
3
- Batteries
- 2 steps
- Outer Casing
- 4 steps
- Volume or Tone Knob
- 1 step
Flags
0
BackSony CFS-204 Radio Cassette-Recorder
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
Batteries
- Press down on the two tabs at the top of the door.
- Rotate the door away from the radio, towards you.
- Lift the door out of the three smaller tabs on the bottom.
- Ensure the radio is turned off to avoid the possibility of electric shock.
- The battery compartment door is not shown.
Press down on the two tabs at the top of the door.
Rotate the door away from the radio, towards you.
Lift the door out of the three smaller tabs on the bottom.
Ensure the radio is turned off to avoid the possibility of electric shock.
The battery compartment door is not shown.
1024
Step 2
Batteries
- Push the batteries against the spring and pull out using your finger to remove them.
- To insert the new batteries, push the negative end of the 1st battery against a spring and follow the diagram pictured to insert the batteries in the correct orientation.
Push the batteries against the spring and pull out using your finger to remove them.
To insert the new batteries, push the negative end of the 1st battery against a spring and follow the diagram pictured to insert the batteries in the correct orientation.
Step 3
Screws
- Remove the 6 screws (30 mm in length) with the Phillips #2 Screwdriver from the large holes marked by arrows on the radio.
Remove the 6 screws (30 mm in length) with the Phillips #2 Screwdriver from the large holes marked by arrows on the radio.
Step 4
Opening
- Press the EJECT button to open the cassette deck.
- Pressing this button is required to allow the front face to separate from the case.
Press the EJECT button to open the cassette deck.
Pressing this button is required to allow the front face to separate from the case.
Step 5
- Grasp the radio from the front and back halves and gently pull apart to separate them.
Grasp the radio from the front and back halves and gently pull apart to separate them.
Step 6
- Pull the white plug out from the red outlet in the Orange circuit board in the back face of the casing.
- Take care not to break the red outlet off the circuit board.
- The front and back portions of the casing are now separated from each other.
Pull the white plug out from the red outlet in the Orange circuit board in the back face of the casing.
Take care not to break the red outlet off the circuit board.
The front and back portions of the casing are now separated from each other.
Step 7
Volume or Tone Knob
- Push upwards against bottom edge of the knob connection with a flat head screwdriver until the knob pops off.
- You may wish to hold on to the knob so you don’t lose it!
Push upwards against bottom edge of the knob connection with a flat head screwdriver until the knob pops off.
You may wish to hold on to the knob so you don’t lose it!
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
3 other people completed this guide.
Author
with 2 other contributors
Brittany Patterson
Member since: 09/17/2014
693 Reputation
4 Guides authored
Badges:
16
+13 more badges
Team
University of Kentucky Louisville, Team 1-1, Mathis Fall 2014
Member of University of Kentucky Louisville, Team 1-1, Mathis Fall 2014
LOUISVILLE-MATHIS-F14S1G1
3 Members
10 Guides authored