Difficulty

Easy

Steps

7

Time Required

                          10 - 20 minutes

Sections

2

  • The Case
  • 3 steps
  • Audio Module
  • 4 steps

Flags

Action Shots

Be an action hero! This guide needs images that better demonstrate how to perform specific actions.

Needs More Images

A few more images would make this guide’s procedures crystal clear.

  • BackSony Clié PEG-NR70

  • Full Screen

  • Options

  • History

  • Save to Favorites

  • Download PDF

  • Edit

  • Translate

  • Get Shareable Link

  • Embed This Guide

  • Notify Me of Changes

  • Stop Notifications

Introduction

What you need

Step 1

              The Case
  • Unscrew the 1.9mm screw located at the top of the device with a Phillips #00 screwdriver.
  • It may be helpful to set up a piece of paper to keep track of where removed screws came from.

Unscrew the 1.9mm screw located at the top of the device with a Phillips #00 screwdriver.

It may be helpful to set up a piece of paper to keep track of where removed screws came from.

1024

Step 2

  • Unscrew the 2.5mm screw located on the left side of the device with a Phillips #00 screwdriver.

Unscrew the 2.5mm screw located on the left side of the device with a Phillips #00 screwdriver.

Step 3

  • Unscrew the five 2.5mm screws on the back panel with a Phillips #00 screwdriver.
  • Remove the back panel by lifting it away with your hands.

Unscrew the five 2.5mm screws on the back panel with a Phillips #00 screwdriver.

Remove the back panel by lifting it away with your hands.

Step 4

              Audio Module
  • Unscrew the 2.5mm screw on the top portion of the audio module with a Phillips #00 screwdriver.

Unscrew the 2.5mm screw on the top portion of the audio module with a Phillips #00 screwdriver.

Step 5

  • Remove the tape that is holding the module down.

Remove the tape that is holding the module down.

Step 6

  • Lift up the orange ribbon cable and unscrew the two 2.5mm screws located at the corners of the audio module with a Phillips #00 screwdriver.

Lift up the orange ribbon cable and unscrew the two 2.5mm screws located at the corners of the audio module with a Phillips #00 screwdriver.

Step 7

  • Unplug the audio module from the motherboard by disconnecting the wires by lifting the orange wire up.

Unplug the audio module from the motherboard by disconnecting the wires by lifting the orange wire up.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 5 other contributors 


                    Daniel Soski

Member since: 04/18/2013

51 Reputation

                                      6 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges

Team

                       Cal Poly, Team 14-11, Maness Spring 2013                        

                                                  Member of Cal Poly, Team 14-11, Maness Spring 2013 



                    CPSU-MANESS-S13S14G11                     


                                            5 Members                     


                                            8 Guides authored