Sony Clie Peg Nr70 Speaker Rail Replacement Repair Guide

Difficulty

Easy

Steps

5

Time Required

                          5 minutes            

Sections

2

• The Case
• 3 steps
• Speaker Rail
• 2 steps

Flags

1

Markup Mishap

This guide needs better markups. Help out by correcting or making some markup annotations.

• BackSony Clié PEG-NR70

• Full Screen

• Options

• History

• Save to Favorites

• Download PDF

• Edit

• Translate

• Get Shareable Link

• Embed This Guide

• Notify Me of Changes

• Stop Notifications

Introduction

What you need

Step 1

              The Case               

• Unscrew the 1.9mm screw located at the top of the device with a Phillips #00 screwdriver.
• It may be helpful to set up a piece of paper to keep track of where removed screws came from.

Unscrew the 1.9mm screw located at the top of the device with a Phillips #00 screwdriver.

It may be helpful to set up a piece of paper to keep track of where removed screws came from.

1024

Step 2

• Unscrew the 2.5mm screw located on the left side of the device with a Phillips #00 screwdriver.

Unscrew the 2.5mm screw located on the left side of the device with a Phillips #00 screwdriver.

Step 3

• Unscrew the five 2.5mm screws on the back panel with a Phillips #00 screwdriver.
• Remove the back panel by lifting it away with your hands.

Unscrew the five 2.5mm screws on the back panel with a Phillips #00 screwdriver.

Remove the back panel by lifting it away with your hands.

Step 4

              Speaker Rail               

• Use tweezers to unplug the speaker wire from the motherboard by pulling the plug (not the wires) down towards the speaker.
• Be careful not to tear the speaker wires! They are very thin.
• Remove the tape holding speaker wire by peeling it away.

Use tweezers to unplug the speaker wire from the motherboard by pulling the plug (not the wires) down towards the speaker.

Be careful not to tear the speaker wires! They are very thin.

Remove the tape holding speaker wire by peeling it away.

Step 5

• Holding down the speaker rail unscrew the two 2.5mm screws with a Phillips #00 screwdriver.
• Remove the speaker rail vertically from the device.

Holding down the speaker rail unscrew the two 2.5mm screws with a Phillips #00 screwdriver.

Remove the speaker rail vertically from the device.

To reassemble your device, follow these instructions in reverse order.

Cancel: I did not complete this guide.

Author

                                      with 6 other contributors 

                    Daniel Soski                     

Member since: 04/18/2013

51 Reputation

                                      6 Guides authored                  



                       Badges:
                       9







                                                        +6 more badges                           

Team

                       Cal Poly, Team 14-11, Maness Spring 2013                        

                                                  Member of Cal Poly, Team 14-11, Maness Spring 2013 



                    CPSU-MANESS-S13S14G11                     


                                            5 Members                     


                                            8 Guides authored