Difficulty
Easy
Steps
6
Time Required
5 minutes
Sections
3
- The Case
- 3 steps
- Speaker Rail
- 2 steps
- Speaker
- 1 step
Flags
1
Markup Mishap
This guide needs better markups. Help out by correcting or making some markup annotations.
BackSony Clié PEG-NR70
Full Screen
Options
History
Save to Favorites
Download PDF
Edit
Translate
Get Shareable Link
Embed This Guide
Notify Me of Changes
Stop Notifications
Introduction
What you need
Step 1
The Case
- Unscrew the 1.9mm screw located at the top of the device with a Phillips #00 screwdriver.
- It may be helpful to set up a piece of paper to keep track of where removed screws came from.
Unscrew the 1.9mm screw located at the top of the device with a Phillips #00 screwdriver.
It may be helpful to set up a piece of paper to keep track of where removed screws came from.
1024
Step 2
- Unscrew the 2.5mm screw located on the left side of the device with a Phillips #00 screwdriver.
Unscrew the 2.5mm screw located on the left side of the device with a Phillips #00 screwdriver.
Step 3
- Unscrew the five 2.5mm screws on the back panel with a Phillips #00 screwdriver.
- Remove the back panel by lifting it away with your hands.
Unscrew the five 2.5mm screws on the back panel with a Phillips #00 screwdriver.
Remove the back panel by lifting it away with your hands.
Step 4
Speaker Rail
- Use tweezers to unplug the speaker wire from the motherboard by pulling the plug (not the wires) down towards the speaker.
- Be careful not to tear the speaker wires! They are very thin.
- Remove the tape holding speaker wire by peeling it away.
Use tweezers to unplug the speaker wire from the motherboard by pulling the plug (not the wires) down towards the speaker.
Be careful not to tear the speaker wires! They are very thin.
Remove the tape holding speaker wire by peeling it away.
Step 5
- Holding down the speaker rail unscrew the two 2.5mm screws with a Phillips #00 screwdriver.
- Remove the speaker rail vertically from the device.
Holding down the speaker rail unscrew the two 2.5mm screws with a Phillips #00 screwdriver.
Remove the speaker rail vertically from the device.
Step 6
Speaker
- Hold back the plastic tabs to pop the speaker out of the rail.
Hold back the plastic tabs to pop the speaker out of the rail.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
Author
with 2 other contributors
Daniel Soski
Member since: 04/18/2013
51 Reputation
6 Guides authored
Badges:
9
+6 more badges
Team
Cal Poly, Team 14-11, Maness Spring 2013
Member of Cal Poly, Team 14-11, Maness Spring 2013
CPSU-MANESS-S13S14G11
5 Members
8 Guides authored
